Pottery Barn Schoolhouse Mini Desk Assembly Instruction
pottery barn kids
SCHOOLHOUSE MINI DESK
IMPORTANT SAFETY INSTRUCTIONS:
Please read all instructions carefully before assembling.
For your safety, assembly by two people is recommended.
PARTS INCLUDED:
(1) Mini Top (A)
(1) Schoolhouse Case (B)
PRE-ASSEMBLY:
• Remove all parts and hardware from the box and lay out on a clear carpeted or scratch-free work surface.
(The shipping box provides an ideal work surface), this will avoid damaging any parts during assembly. Do
not dispose of any contents until assembly is completed to avoid accidentally discarding small parts or
hardware.
• Use the parts and hardware lists above to identify and separate each of the pieces included.
• The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions.
• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause
the bolts to misalign during assembly.
• If using power tools to aid in assembly please use caution. Power tools can damage hardware or split
wood.
ASSEMBLY INSTRUCTIONS:
1. Carefully remove top 2 drawers from Schoolhouse Case (B) as shown.
2. Place Mini Top (A) on the top of Schoolhouse Case and secure by using (2) Allen Bolts, Flat Washers &
Spring Washers. Note: The correct order for the washers to go on the Allen Bolt is: Spring Washer first, Flat
Washer second. Please see diagram.
3. Place 2 drawers of Schoolhouse Case back to complete the assembly.
CARE INSTRUCTIONS:
• Dust with a clean, soft cloth.
• Avoid the use of chemicals and harsh cleaning a gents.
• Do not stand on the base.
HARDWARE ENCLOSED:
(1) Allen Key (C)
(2) ¼” x 25mm Allen Bolts (D)
(2) ¼” Spring Washer (E)
(2) ¼” Flat Washer (F)
Thank you for your purchase.
stores | catalog | www.potterybarnkids.com
TOOLS REQUIRED FOR ASSEMBLY:
(1) Allen Key
pottery barn kids
SCHOOLHOUSE STORAGE BASE
HARDWARE HANDING KIT
IMPORTANT SAFETY INSTRUCTIONS:
Please read all instructions carefully before assembling.
HARDWARE ENCLOSED:
(2) Metal Bar
PRE-ASSEMBLY:
• Remove all parts and hardware from the box and lay out on a clear carpeted or scratch-free work surface
(The shipping box provides an ideal work surface), as this will avoid damaging any parts during assembly.
Do not dispose of any contents until assembly is completed to avoid accidentally discarding small parts or
hardware.
ASSEMBLY INSTRUCTIONS:
1. Remove Metal Bars and Hanging Clips from the hardware plastic bag.
2. Open the bottom drawer and connect 2 clips on each side of the drawer pan el. Place the metal bars on
the clips as shown in the illustration below.
CARE INSTRUCTIONS:
• Dust with a clean, soft cloth.
• Avoid the use of chemicals and harsh cleaning a gents.
• Do not stand on the base.
(4) Hanging Clip
Thank you for your purchase.
stores | catalog | www.potterybarnkids.com
Loading...