Pottery Barn Sawyer Sleigh Trundle Assembly Instruction

Page

1/4

pottery barn kids

SAWYER SLEIGH

BED

TRUNDLE

PRE-ASSEMBLY:



Please read all instruction

s

before beginning assembly. The illustrationsprovided allow for easierassembly

when used in conjunction with the ass

embly i

nstructions.



For your safety and ease, as

sembly by two adults is recommended.



Removeall parts and hardware from box and lay out on a carpetedor scratch

-

fee work surface, as this will

avoid

d

amaging any parts during assembly.The shipping box provides and ideal work surface.

Do not dispose

of an

y contents until assemblyis completedto avo

id accidentallydiscarding

small

parts or hardware.



Use the parts and hardware lists to identify and separate each of the pieces included.



Note: Do not fully tighten all bolts untilall parts are in place. Failu

re to followtheseinstructions may cause the

bolts to misalign during assembly.



The use of power tools for assembly is not recommended. Power tools can damage hardware or split wood.

PARTS INCLUDED:

A-Side B

ottom

B

oard

with

Protruding Edge

at one si

de(2pcs)B-Middle Bottom B

oard

with

Sunken Edge

at both side

(1

pcs)C-Wooden Rail

(2

pcs)D-Long Side Rail (2 pcs)

E-Short

S

ideRail (2

pcs)HARDWARE INCLUDE

D:F-Phillip Head Screw #

8x30 mm

(22 pcs

)G-

Barrel Nut

6x13x10mm

(

8 pcs

)H-

Allen Bolt

M6 x 60 mm

(8

pcs)I-Caster 40x60x70mm

(6

pcs)J-Pan Head Screw

#4

x 12 mm

(24 pcs)

K-Allen Key

M6(1pcs)TOOLS REQUIRED:

Phillips Head Screwdriver (Not incl

uded)

Page

2/4

ASSEMBLY

INSTRUCTIONS

:

1. Slot the Middle Bottom Board (B) into the Side Bottom Boards (A) with the pre

-

drilled holes on the Side

Bottom Boards facing up. Attach the Wooden Rails (C)

by inserting

the wood dowels on the

Railsinto the

pre-drilled ho

les on the Side Bottom Boards

(A)

as shown. Secure

with

(12) Phillips Head Screws (F)

using

Screwdriver

. See Fig. 1.

Fig. 1

CCFAB

2. Turn the assembled bottom boards over

. Insert

the Long Side Rails (D) and Short Side Rails (

E)into

the

slots in the

bottom boards as shown. Connect rails by using two (2) Barrel Nuts (G) and two (2)

A

llen Bolts

(H) at each corner

, as shown in Figure 2

. Secure Allen Bolts with enclosed Allen Key (K).

Note:

To access the bottom Barrel Nut openin

gs, assemble the four upper bolts and then turn the

assembled structure on its side to assemble the four bottom bolts. Do not fully tighten until all

bolts are in place

Fig. 2

EHGDDEK

Grooves on Long and Short Side Rail

cut for Bottom Board

Dowel under Wood Rail

Pre-Drilled holes on Bottom Board