Pottery Barn Riley Bed Storage Cart Assembly Instruction

pottery barn kids

RILEY BED STORAGE CART

PRE-ASSEMBLY:

• Read all instructions before beginning assembly. The illustrations provided allow for easier assembly when
used in conjunction with the asse mbly instruction s.

• For your safety and ea se, assembly by two adults is recommended.

• Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work surface.

Use care as some parts or hardw a re may ha ve sh arp poin ts or edge s.

• Do not dispose of any contents until assembly is completed to avoid accidentally discarding small parts or
hardware.

• Use the parts and hardware lists to identify and separate each of the pieces included.

• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause

the bolts to misalign during assembly.

• The use of power tools for assembly is not recommended. Power tools can damage hardware or split wood.

PARTS INCLUDED:
(A) Left and Right Bottom Board – 2pcs

(B) Center B ottom Board – 1pc
(C) Front Panel – 1pc
(D) Rear Panel – 1pc
(E) Side Panel – 2pcs

HARDWARE INCLUDED:

(F) Caster – 5pcs

(I) Allen Key – 1pc

(L) Flat Washer – 8pcs

(G) Short Wood Screw

(J) Allen Bolt 1/4”x25mm – 8pcs

TOOLS REQUIRED:
Philips Screwdriver (Not included)

3-2x12mm – 20pcs

(H) Long Wood Screw

4 x 25mm – 12pcs

(K) Spring Washer – 8pcs

Page 1/3

ASSEMBLY INSTRUCTIONS:

1. Slide the (3) Bottom Boards (A&B) into the slots on the Side Panels (E), with the pre-drilled holes

facing down, (Figure 1). Make sure the Center Bottom Board (B) (without pre-drilled holes on long
edges) is placed in center, as shown.

2. To attach the Front/Rear Panels (C&D) to the assembled piece, align the pre-drilled holes on the

Front/Rear Panels (C&D) to wooden dowels on the Side Panels (E). Slide a Spring Washer (K), a Flat
Washer (L) into an Allen Bolt (J) and insert the bolt into a pre-drilled hole on cleats of the Side Panel (E)
using an Allen Key (I), as shown in Figure 1. Repeat with the other (7) bolts.

Figure 1.

3. Turn the assembled piece upside d own. Secure the Bottom Boards to the Front/Rear/Side Panels

using (12) Long Wood Screws (H). (Figure 2). Do not over tighten.

Figure 2.

Page 2/3