
pottery barn kids
PIRATE BED TRUNDLE
PRE-ASSEMBLY:
• Read all instructions before beginning assembly. The illustration provided allow for easier assembly
when used in conjunction with the assembly instructions.
• For your safety and ease, assembly by two adults is recommended.
• Remove all parts and hardware may have sharp points or edges.
• Do not dispose of any contents until assembly is completed to avoid accidentally discarding small
parts or hardware.
• Use the parts and hardware lists to identify and separate each of the piece included.
• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may
cause the bolts to misalign during assembly.
• The use of power tools for assembly is not recommended. Power tools can damage hardware or
split wood.
PARTS INCLUDED:
A – Long side panel (2)
B – Short side panel (2)
C – Left and Right Board (with extra holes) (2)
D – Center Bottom Board (1)
E – Cross bar (2)
TOOLS REQUIRED:
Phillips screw driver (not included)
HARDWARE INCLUDE
F –Allen Key (1) G –Long bolt 1/4 ”x2-1/2”x13.5mm (8)
H –Barrel nut 1/4”x15x9.5mm (8) I –Large Phillips head screw 8x38mm (12)
1/5

J – Small Phillips head screw 8x25mm (10) K – Pan head screw 8x17mm (24)
L – Flat head screw 5/32”x16mm (8) M – Trundle handle 92x40x22mm (4)
Caster 50x50x65mm (6)
N –
ASSEMBLY:
1. Place the left and right bottom panel (C) on either side of the Center bottom board (D) with the predrilled holes facing up as shown. Attach Cross bar (E) to the bottom boards by inserting Large Phillips
head screw 8x38mm (I) into the pre-drilled holes of each cross bar, tightening with a phillips
screwdriver.
2/5

2. Turn assembled base right side up, Insert the wooden dowels on the ends of the Cross bars (E) into
the pre- drilled holes on the Long side panel (A) as shown. Press firmly to ensure the left and right
Bottom boards (C ) sit in the slots of the Long side panel (A).
3. Align the pre-drilled holes on the Short side panel (B) to the wooden dowels on ends of the Long side
panel (B) . insert the Allen bolts (G) into the pre-drilled hols on the Short side panel (B) . place barrel
nut (H) in the corresponding opening on the Long side panel(B) . use Allen key (F) to connect as shown.
Repeat with the remaining bolts.
3/5

4. Turn trundle upside down. Secure bottom boards with the Long/Short side panel using the Small
Phillips head screw 8x25mm (J).
5. Attach the Caster (N) to pre-drilled holes on the Bottom Board using 24pcs Pan head screw 8x17mm
(K).
J
4/5

6.
Fasten the Trundle Handles (M) to the trundle using Flat Head Screws (L), assembly completed.
CARE INSTRUCTION:
• Dust often using a clean, soft, dry lint-free cloth.
• Blot spills immediately, and wipe with a clean, damp, cloth.
• We do not recommend the use of chemical cleansers, abrasives, or furniture polish on our
lacquered finish.
Thank you for your purchase
stores | catalog | www.potterybarnkids.com
5/5