Pottery Barn Olivia Daybed Assembly Instruction
pottery barn kids
OLIVIA DAYBED TRUNDLE
PRE-ASSEMBLY:
• Please read all instructions before beginning assembly. The illustrations provided allow for easier assembly when
used in conjunction with the assembly instructions.
• For your safety and ease, assembly b y tw o adults is re commend ed.
• Remove all parts and hardware from box and lay out on a carpeted or scratch-fee work surface, as this will avoid
damaging any parts during assembly. The shipping box provides and ideal work surface. Do not dispose of any
contents until assembly is completed to avoid accidentally discarding email parts or hardware.
• Use the parts and hardware lists to identify and separate each of the pieces included.
• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause the bolts to
misalign during assembly.
• The use of power tools for assembly is not recommended. Power tools can damage hardware or split wood.
PARTS INCLUDED:
(A) Front Rail (with moulding) – 1pc
(B Back Rail – 1pc
(C) Side rails - 2pcs
(D) Side Bottom Board with pre-drilled holes - 2pcs
(E) Center Bottom board-1pc
(F) Cross bar -2pcs
HARDWARE ENCLOSED:
(G) 1/4” x 2-1 /2” Allen Bolt - 8pcs
(H) Barrel Nut - 8pcs
(I) #8 x 1-1/4” Screw - 22pcs
(J) #7x12mm Screw - 24pcs
(K) Casters - 6pcs
(L) 4mm Allen key - 1pc
TOOLS REQUIRED:
Phillips head screwdriver (not included)
C
B
D
F
E F
C
D
A
Page 1/4
ASSEMBLY INSTRUCTIONS:
1. Lay the Side Bottom Boards (D) and Center Bottom board (E) on your work surface with the pre-drilled holes facing
up, as shown in Figure 1. Attach the Cross bars (F) by inserting the #8 x 1-1/4” Screws (I) into the pre-drilled holes,
and tightening with the Phillips screwdriver (not included). Then, attach the Casters (K) into the pre-drilled holes on the
Bottom boards, using #7x12mm screws (J), as shown.
(Fig. 1)
2. Lay the Back rail (B) on a soft surface with the groove facing up. Attach wood dowel of end of Cross Bar (F) to pre-
drilled wood dowel holes of Back Rail (B) as shown in Figure 2. Repeat to attach Front Rail (with moulding) (A).
(Fig.2)
K
J
F
D
E
A
B
F
I
F
D
F
B
Page 2/4
Loading...