Pottery Barn Nautical Trundle Assembly Instruction

pottery barn kids

D

A

B

C

A

nautical trundle

Important Safety Message:
Use only vendor-supplied hardware to assemble. Using unauthorized hardware could jeopardize the structural

integrity of the item.
PRE-ASSEMBLY

• Please read all instructions carefully before beginning assembly.

• Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work surface,

as this will avoid damaging any parts during assembly. The shipping box provides an ideal work surface. Do
not dispose of any contents until assembly is completed to avoid accidentally discarding small parts or
hardware.

• We recommend adult assembly by two people for your safety.

• Save all packaging materials until assembly is complete to avoid accidentally discarding smaller parts or

hardware.

PARTS ENCLOSED:

(A) Left & Right Base – 2pcs
(B) Center Base – 1pc
(C) Base Support Rail – 2pcs
(D) Side Panel – 2pcs
(E) End Panel – 2pcs

TOOLS REQUIRED:

(O) Allen Key (included)
Philips Screwdriver
(not included)

A

ASSEMBLY INSTRUCTIONS:

1. Lay the Left and Right Base Panels (A) and the Center Base Panel (C) on your work-surface with the pre­drilled holes facing up. Place each of the Casters (M) over the pre-drilled holes located on all three panels.
Fasten each of the (6) casters with (4) M4 x 16 mm CBS screws (N) using a Philips Screwdriver (not
included). (Fig. 1)

(Fig. 1)

HARDWARE ENCLOSED:

(F) Dowel – 6pcs
(G) M4 x 50 mm CBS – 12pcs

E

(H) M4 x 30 mm CBS – 10pcs
(I) JCBC M6 x 60 mm JCBC –
8pcs
(J) Flat washer – 8pcs
(K) Spring washer – 8pcs
(L) Barrel screw – 8pcs
(M) Caster – 6pcs
(N) CBS M4 x 16 MM – 24pcs

N

M

CFABACGCL

D

2. Insert (3) Dowels (F) into the pre-drilled holes located on both Base Support Rails (C).

(Fig. 2)

3. Align the Left & Right Base (A) and Center Base (B) as shown. NOTE: Ensure the pre-drilled holes of the
Panels are facing UP. Place the Base Support Rails (C) on the Base Panels (A&B) and secure them with
(12) M4 x 50 mm CBS screws (G) using Philips Screwdriver (not included). (Fig. 3)

(Fig. 3)

4. Insert all of the Barrel screws (L) into the pre-drilled holes located on the Side Panel (D). Ensure the arrow on
each Barrel screw (L) points toward the hole in the edge of the Side Panel (D). If you need to adjust the barrel
screw to accomplish this, use a Philips Screwdriver (not included). Repeat with the remaining Side Panel (D).
(Fig. 4)

(Fig. 4)