Pottery Barn Madeline XW Dresser Hutch Assembly Instruction

pottery barn kids

MADELINE XW DRESSER HUTCH

PRE-ASSEMBLY:

• Please read all instructions carefully before beginning assembly. The illustrations provided allow for easier
assembly when used in conjunction with the assembly instructions.

• Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work surface,
as this will avoid damaging any parts during assembly. The shipping box provides an ideal work surface. Do
not dispose of any contents until assembly is completed to avoid accidentally discarding small parts or
hardware.

• For your safety and ease, adult assembly by two people is recommended.

• Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts.

• Use the parts and hardware lists above to identify and separate each of the pieces included.

• The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions.

• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause the

bolts to misalign during assembly.

• If using power tools to aid in assembly please use caution. Power tools can damage hardware or split wood.

PARTS INCLUDED:
A - Base (x1 )
B -Top Mirror (x1)

TOOLS INCLUDED:
Phillips Head Screwdriver (not included)

Allen Key (included)

HARDWARE:
C - Allen Key (x1)

D - Short Bolt 5/16”x32x15mm (x3)

E - Spring Washer 5/16”x13x2mm (x3)

F - Flat Washer 5/16”x16x2mm (x3)

G - Metal Plate 70x40mm (x2)

H - Small Phillips Head Screws 7x15mm (x8)

1

I - Bracket 48x21x10mm (x2)

J - Long Screw 6x32mm (x2)

K - Short Screw 6x19mm (x2)

L - Nylon Strap 300x12x8mm (x1)

ASSEMBLY:

1. Press the drawer stopper up as shown and pull out (3) drawers as shown (Figure 1).

(Figure 1)

2. Align the wooden dowels on Mirror (B ) to wooden dowel h oles on Base (A) as shown, and place the Mirror onto the
Base. Using the Allen Key (C), attach the two pieces by inserting the Short Bolt (D), S pring W asher (E ), Flat W asher
(F) from inside the drawer openings, as shown (Figure 2).

(Figure 2)

2