Pottery Barn Madeline Daybed Assembly Instruction
pottery barn kids
MADELINE DAYBED
PRE-ASSEMBLY:
• Remove all parts and hardware from the box and lay out on a clean carpeted or scratch-free work surface (The shipping
box provides an ideal work surfa ce ) . This will avoid damaging any p arts during assembly. Do not dispose of any contents
until assembly is completed to avoid accidentally discarding small parts or hardware.
• Two peopl e re commend ed for ea se o f asse mb ly.
• Use the parts and hardware list s to iden tify and separate each of the pieces included prior to starting assemb ly.
• The illustrations provided allow for easier assembly w hen used in conj unction w i th the assemb ly in stru ction s.
• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause the bolts to
misalign during assembly.
• If using power tools to aid in assembly please use caution. Power tools can damage hardware or split wood.
• The images in these instructions may depict the product ordered with a floral appliqué. If you ordered the
product without the floral appliqué, please disregard that depiction and assemble as instructed.
PARTS INCLUDED:
A – Rear panel (x1)
B – Right panel (x1)
C – Left panel (x1)
D – Front rail (x1)
E – Slat roll (x1)
TOOLS REQUIRED:
Phillips head screwdriver (not included)
(G) Wrench (x1)
HARDWARE INCLUDED:
F – Long bolt (x4) H – Metal washer (x4)
I – Spring washer 5/16”x13mm (x4) J – Lock washer (x4)
K – Large Phillips head screw (x28)
1
ASSEMBLY:
1. Hold Front rail (D) and Rear panel (A) up to slots on the legs of the Right side p anel (B). Insert the Front rail (D)
and Rear panel (A) to the Right side panel (B) using the long bolts (F). Fasten them using the met al washer (H),
spring washer 5/16”x13mm (I), Lock washer (J) as shown below. Repeat the same steps with the left side
panel (C).
2. Lay the Slat roll (E) on the rails of the back and front panels. Using a Phillips head screwdriver , fasten the slat s
to the rails with the Phillips head screws (K) as shown below.
2
Loading...