![](/html/e8/e8f9/e8f93acd4b2a85d4e760a05d1ed2ff0c2c1f861a9ffe63314a3e398a54450317/bg1.png)
pottery barn kids
MADELINE 2 SHELF BOOKCASE
PRE-ASSEMBLY:
• Read all instructions before beginning assembly. The illustrations provided allow for easier assembly
when used in conjunction with the assembly instructions.
• For your safety and ease, assembly by tw o adult s is r ecommend ed.
• Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work
surface. Use care as some pa rt s or hardw a re ma y ha ve sharp po in t s or edges.
• Do not dispose of any contents until assembly is completed to avoid accidentally discarding small parts or
hardware.
• Use the parts and hardware lists to identify and separate each of the pieces included.
• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may
cause the bolts to misalign during assembly.
• The use of power tools for assembly is not recommended. Power tools can damage hardware or split
wood.
P ARTS INCLUDED:
A – Top panel (x1)
B – Right side panel (x1)
C – Left side panel (x1)
D – Shelf (x1)
E – Bottom Panel (x1)
F – Back panel (x1)
TOOLS REQUIRED:
Phillips head screwdriver (not included)
G - Allen Key (included)
HARDWARE ENCLOSED:
H –Allen Bolts 1/4”x1-1/8” x15mm (x8) I –Phillips head screws 8x32mm (x8)
J – Phillips head screws 8x25mm (x6) K – Phillips head screws 6x19mm (x24)
Page 1/3
![](/html/e8/e8f9/e8f93acd4b2a85d4e760a05d1ed2ff0c2c1f861a9ffe63314a3e398a54450317/bg2.png)
ASSEMBLY INSTRUCTIONS
1. On a soft, scratch-free surface such as carpet or rug, lay the Right side panel (B) down as shown.
Attach the Shelf (D) and Bottom panel (E) to the Right side panel (B) using the Allen Bolts (H) and
Allen Key (G). (Figure 1)
Figure 1
2. Attach the Left side panel (C) as shown. Secure the Shelf (D) and Bottom panel (E) to the Left side
panel (C) using the Allen Bolts (H) and Allen Key (G) (Figure 2).
3. Affix the Bottom panel (E) to both Right side panel (B) and Left side panel (C) using Phillips head
screw 8x32mm (I). (Figure 3).
Figure 2
Figure 3
Page 2/3