Pottery Barn Logan Trundle Assembly Instruction

pottery barn kids

LOGAN TRUNDLE

PRE-ASSEMBLY:

• Remove all parts and hardware from the box and lay out on a clear carpeted or scratch-free work surface, as this
will avoid damaging parts during assembly. The shipping box provides an ideal work surface. Do not dispose of
any contents until assembly is completed to avoid accidentally discarding small parts or hardware.

• Two adults recommended for ease of assembly.

• Use the parts and hardware lists to identify and separate each of the pieces included prior to starting assembly.

• The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions.

• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause the

bolts to misalign during assembly.

• If using power tools to aid in assembly please use caution. Power tools can damage hardware or split woo d.

PARTS INCLUDED:
(A) Long siderail – 2pcs (B) Short siderail – 2pcs

(C) Side bottom board with protruding edge – 2pcs (D) Middle bottom board with sunken edge – 1pc

(E) Wooden bottom board support – 2pcs

HARDWARE ENCLOSED
(F) Large Phillips head screw 8x38mm – 12pcs (G) Allen Key (1)

(H) Long bolt 1/4”x2-1/2” x 13.5mm – 8pcs (I) Barrel nut 1/4”x15x9.5mm – 8pcs

(J) Small Phillips head screw 8x25mm – 10pcs (K) Pan head screw 8x17mm – 24pcs

(L) Caster 50x50x65mm – 6pcs

TOOLS REQUIRED:
Phillips screw driver (not included)

ASSEMBLY INSTRUCTIONS:

1. Slot the Middle bottom board (D) into the (2) Side bottom boards (C). Attach the Wooden bottom board supports
(E) to the assembly as shown using (12) Large Phillips head screws (F) . (Fig. 1)

(Fig. 1)