Pottery Barn Larkin Sleigh Twin and Full Bed Assembly Instruction

pottery barn kids

LARKIN BED TWIN/FULL

PRE-ASSEMBLY:

• For safety and ease, assembly by two adults is recommended.

• Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work surface. Use

care as some parts or hardware may have sharp points or edges. Do not dispose of any contents until assembly
is completed to avoid accidentally discarding small parts or hardware.

• Use the parts and hardware lists to identify and separate each of the pieces included.

• Read all instructions before beginning assembly. The illustrations provided allow for easier assembly when used

in conjunction with the assembly instructions.

• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause the
bolts to misalign during assembly.

• The use of power tools for assembly is not recommended. Power tools can damage hardware or split wood.

PARTS INCLUDED:
(Box #1) (Box #2)

A - Headboard (1pcs) B - Footboard (1pcs)

(Box #3)

C - Side Rail (2pcs)

HARDWARE INCLUDED:
(Box #1)

E - Wood Screw, 8 x 30 mm (32 pcs)

TOOLS REQUIRED:
Phillips Head Screwdriver (Not included)

D - Slat Roll (1pcs)

Page 1/2

ASSEMBLY INSTRUCTIONS:

1. Attach the Side Rails (C) to the Headboard (A) and Footboard (B) by inserting the hooked ends into the
corresponding slots, as shown in Figure 1. Ensure that the connections are secure.

NOTE: Side Rails (C) are adjustable to two heights:

z Use the higher setting if not using a box spring mattress and/or if a trundle will be used with the bed.
z Use the lower setting if using a mattress & box spring. We recommend a box spring if you want to use a bed

skirt or add height to the bed.

z Our beds do not require a box spring at either setting

A

Figure 1

There are three (3) pins inside the slot, for two (2)
levels of side rail height.

High level: insert side rail onto 2 upper pins
Low level: insert side rail onto 2 lower pins

C

C

B

3. Lay Slat Roll (D) in place onto the inner edges of the Side Rails (C). Attach Slats Roll (D) by inserting the

Wood screws (E) through the pre-drilled end holes and tightening with Phillips Head Screwdriver (not
included), as shown in Figure 2.

E

Figure 2

C

D

4. Periodically tighten all connections.

CARE INSTRUCTIONS:

• Dust often using a clean, soft, dry lint-free cloth.

• Blot spills immediately, and wipe with a clean, damp, cloth.

• We do not recommend the use of chemical cleansers, abra sives, or furniture polish.

Thank you for your purchase

stores | catalog | www.potterybarnkids.com

USA 1.800.290.8181

Page 2/2