Pottery Barn Larkin Sleigh Trundle Bed Assembly Instruction
pottery barn kids
LARKIN BED TRUNDLE
PRE-ASSEMBLY:
• Please read all instructions before beginning assembly. The illustrations provided allow for easier assembly
when used in conjunction with the assembly instructions.
• For your safety and ease, assembly by two adults is recommended.
• Remove all parts and hardware from box and lay out on a carpeted or scratch-fee work surface, as this will
avoid damaging any parts during assembly. The shipping box provides and ideal work surface. Do not
dispose of any contents until assembly is completed to avoid accidentally discarding small parts or hardware.
• Use the parts and hardware lists to identify and separate each of the pieces included.
• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause the
bolts to misalign during assembly.
• The use of power tools for assembly is not recommended. Power tools can damage hardware or split wood.
PARTS INCLUDED:
A - Side Bottom Board with
Protruding Edge at one side (2 pcs)
B - Middle Bottom Board with
Sunken Edge at both side (1 pcs)
C - Wooden Rail (2 pcs)
D - Long Side Rail (2 pcs) E - Short Side Rail (2 pcs
HARDWARE INCLUDED:
F - Phillip Head Screw #8x30 mm
(22 pcs)
I - Caster
40x60x70mm (6 pcs)
G - Barrel Nut 6x13x10mm
(8 pcs)
J - Pan Head Screw
#4 x 12 mm (24 pcs)
H - Allen Bolt M6 x 60 mm
(8pcs)
K - Allen Key M6 (1 pcs)
TOOLS REQUIRED:
• Phillips Head Screwdriver (Not included)
Page 1/4
ASSEMBLY INSTRUCTIONS:
1. Slot the Middle Bottom Board (B) into the Side Bottom Boards (A) with the pre-drilled holes on the Side
Bottom Boards facing up. Attach the Wooden Rails (C) by inserting the wood dowels on the Rails into
the pre-drilled holes on the Side Bottom Boards (A) as shown. Secure with (12) Phillips Head Screws
(F) using the Screwdriver. See Fig. 1.
Fig. 1
Dowel under Wood Rail
F
Pre-Drilled holes
on Bottom Board
A
C
B
C
2. Turn the assembled bottom boards over. Insert the Long Side Rails (D) and Short Side Rails (E) into
the slots in the bottom boards as shown. Connect rails by using two (2) Barrel Nuts (G) and two (2)
Allen Bolts (H) at each corner, as shown in Figure 2. Secure Allen Bolts with enclosed Allen Key (K).
Note: To access the bottom Barrel Nut openings, assemble the four upper bolts and then turn
the assembled structure on its side to assemble the four bottom bolts. Do not fully tighten
until all bolts are in place.
Fig. 2
H
D
E
G
K
H
G
D
E
Grooves on Long and Short Side Rail cut
for Bottom Board
Page 2/4
Loading...