Pottery Barn Larkin 4-Poster Trundle Assembly Instruction

pottery barn kids

LARKIN 4 POSTER BED TRUNDLE

PRE-ASSEMBLY:

• Please read all instructions before beginning assembly. The illustrations provided allow for easier assembly
when used in conjunction with the assembly instructions.

• For your safety and ease, assembly by two adults is recommended.

• Remove all parts and hardware from box and lay out on a carpeted or scratch-fee work surface, as this will

avoid damaging any parts during assembly. The shipping box provides and ideal work surface. Do not
dispose of any contents until assembly is completed to avoid accidentally discarding email parts or hardware.

• Use the parts and hardware lists to identify and separate each of the pieces included.

• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause the

bolts to misalign during assembly.

• If using power tools to aid in assembly please use caution. Power tools can damage hardware or split wood.

PARTS INCLUDED:

A - Side Bottom Board

with Protruding Edge (2 pcs)

B - Middle Bottom Board

with Sunken Edge (1 pcs)

C - Wooden Rail (2 pcs)

D - Long Side Rail (2 pcs) E - Short Side Rail (2 pcs

HARDWARE INCLUDED:

F - Phillip Head Screw #8x30 mm
(22 pcs)

I - Caster

40x60x70mm (6 pcs)

TOOLS REQUIRED:

z Screwdriver (Not Included)
z Phillips Head Screwdriver (Not included)

G - Barrel Nut 6x13x10mm
(8 pcs)

J - Pan Head Screw

#4 x 12 mm (24 pcs)

H - Allen Bolt M6 x 60 mm
(8pcs)

K - Allen Key (1 pcs)

Page 1/4

ASSEMBLY:

1. Insert the Middle Bottom Board (B) into the two Side Bottom Boards (A) with the pre-drilled holes on

the Side Bottom Boards (A) facing up. Attach the Wooden Rails (C) to the assembly by inserting the
wood dowels on the Wooden Rail into the pre-drilled holes on the Side Bottom Boards as shown.
Secure the Wooden Rails by using twelve (12) Phillips Head Screws #8x30mm (F). See Fig. 1.

Fig. 1

Dowel under Wood Rail

Pre-Drilled holes
on Bottom Board

2. Turn the assembled piece over. Attach the Long Side Rails (D) and Short Side Rails (E) to the Bottom

Boards as shown. Connect rails by using two (2) Barrel Nuts (G) and two (2) Allen Bolts M6 x 60 mm (H) at
each corner. Secure Allen Bolts with enclosed Allen Key (K). See Fig 2.

Fig. 2

D

E

K

H

G

D

E

Grooves on Long and Short Side Rail cut
for Bottom Board

Page 2/4