pottery barn kids
KENDALL BED
CAUTION: Assembly required. This item contains small parts that have sharp
points and edges in the unassembled state. Care should be taken when
unpacking and assembling this item.
Please read all instructions before beginning assembly.
For ease of assembly two people are recommended.
Save all packing materials until assembly is complete to avoid accidentally
discarding smaller parts or hardware.
TOOL REQUIRED:
-Page 1 of 4-
Phillips head screwdriver (not included) (B)
PARTS INCLUDED:
(1) Headboard (C)
(1) Footboard (D)
(2) Side rails (E)
(1) Slat roll (F)
(4) Finials (G)
HARDWARE INCLUDED:
(30) Phillips head screws (A)
-Page 2 of 4-
ASSEMBLY:
1. Place headboard at desired location in room.
2. Attach a side rails to the headboard by hooking the end of the side
3. Now attach the other end of the side rails to the footboard using the
rails into the slots and applying downward force until they are fully
in place. NOTE: side rails have (2) setting, use the higher setting if
a trundle will be used with the bed.
same procedure as step #2.
4. Install the slat roll in between the side rail as shown.
5. Secure the slats by fastening (1) Phillips head screw through the
hole at the end of the slat and into the side rail.
-Page 3 of 4-
The use of power tools during the assembly of this item can cause the hardware to strip or the
wood to split. Please proceed with extreme care.
CARE:
To clean, wipe with a soft dry or slightly damp cloth.
Thank you for your purchase
-Page 4 of 4-
Loading...