pottery barn kids
JANIE BED
PRE-ASSEMBLY:
• Read all instructions before beginning assembly. The illustrations provided allow for easier assembly when used in
conjunction with the assembly instructions.
• For your safety and ease, assembly by two adults is recommended.
• Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work surface. Use
care as some parts or hardware may have sharp points or edges.
• Do not dispose of any contents until assembly is completed to avoid accidentally discarding small parts or hardware.
• Use the parts and hardware lists to identify and separate each of the pieces included.
• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause the
bolts to misalign during assembly.
• The use of power tools for assembly is not recommended. Power tools can damage hardware or split wood.
PARTS INCLUDED:
A. Headboard (1)
B. Footboard (1)
C. Siderails (2).
D. Slat Roll (1)
HARDWARE INCLUDED:
E. Screw FCS Ø7x1¼ Inch (32)
TOOLS REQUIRED:
Phillips screwdriver (not included)
A
C
D
C
B
Page 1/2
ASSEMBLY INSTRUCTIONS:
1. Attach the Side Rails (C) to the Headboard (A) and Footboard (B) by inserting the hooked ends into the
corresponding slots, as shown in Figure 1. Ensure that the connections are secure.
NOTE: Side Rails (C) are adjustable to two heights:
• Use the higher setting if not using a box spring mattress and/or if a trundle will be used with the bed.
• Use the lower setting if using a mattress & box spring. We recommend a box spring if you want to use a bed
skirt or add height to the bed.
• Our beds do not require a box spring at either setting
There are three (3) pins inside the slot, for two (2)
levels of side rail height.
High level: insert side rail onto 2 upper pins
Low level: insert side rail onto 2 lower pins
C
C
B
(Fig.1)
2. Lay Slat Roll (D) in place onto the inner edges of the Side Rails (C), with the straps facing upward. Attach Slat Roll (D)
by inserting the Screws (E) through the pre-drilled holes and tightening with the Phillips Head Screwdriver (not
included), (Figure 2).
E
(Fig.2)
D
CARE INSTRUCTIONS:
• Dust often using a clean, soft, dry lint-free cloth.
• Blot spills immediately, and wipe with a clean, damp, cloth.
• We do not recommend the use of chemical cleansers, abrasives, or furniture polish on our lacquered finish.
Thank you for your purchase
Store l Catalog l www.potterybarnkids.com
USA 1.800.290.8181
Page 2/2