Pottery Barn Farmhouse Desk Assembly Instruction

pottery barn kids

FARMHOUSE DESK

PRE

-

ASSEMBLY:



Please read all instruction before beginning assembly.

The illustrations provided allow for easier assembly

when used in conjunction with the assembly instructions.



Remove all parts and hardware from box and

lay out on a carpeted or scratch

-

free work

surface,

as t

his will

avoid damaging any parts during assembly. The shipping box provides and ideal work surface

.

Do not dispose

of any contents until assembly is completed to avoid accidentally discarding small p

arts or hardware.



For your safety and

ease, adult assembly

by t

wo people is recommended.



Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or

hardware.



Use the parts and hardware lists to identify and se

parate each of the pieces included prior to starting

assembly.



Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause the

bolts to misalign during assembly.



If using power tools to aid in assembly

please use caution. Power tools can damage hardware or split wood.

PARTS INCLUDED:

(A)

Table Top

-1pc(B

) Leg

s-4pcs

TOOLS

REQUIR

ED:

Phillips head screwdriver (not included)

HARDWARE

ENCLOSED

:(C)Ø

10x48mm Nuts

-4pcs(D)1/4x76mmBolts

-8pcs

(E)

Flat

Washer 1/4mm

–

8pcs

(F) Spring washer 1/4mm

–

8pcs

(G) Nuts 1/4mm

–

8pcs

(H) Spanner

–

1pc

A

B

ASSEMBLY

INSTRUCTIONS

:

1.

1.

Insert the Bolts (D) into the pre

-

drilled holes on

Leg(B) as

shown

. Insert the

Bolts (D)

into the pre

-

drilled holes

on the top of the leg (B) to receive the

Nut(C).Tighten with a screwdriver, but do not over tight.

Repeat same

process for the other 3

L

egs. (Fig. 1)

.

(Fig. 1)

2.

Lay tabletop (A) face down on your work surface and position one of the Desk legs (B) exactly as shown in

illustration below.

A

lign the pre

-

drilled holes in each leg with the pre

-

drilled holes in the corner braces of the

table top.. Insert 1 Flat washer (E) and 1 Spring washer (F) and 1 Nut (F) per leg as shown.

Fully tighten with

the enclosed spanner (H).

Repeat same process f

or the other 3 legs. (Fig.

2)(Fig. 2)

B

CDABHEF

G