Pottery Barn Farmhouse Activity Table Assembly Instruction

pottery barn kids

FARMHOUSE

ACTIVITY TABLE

WARNING:

FALL HAZARD

–

To prevent death or serious injury from falls, always

keep child within arm’s reach. NEVER LEAVE CHILD UNATTENDED and always use restraining system.

This changing table is in

tended for use with children weighing up to 50 pounds.

Do not use the changing table if it is damaged or broken.

PRE

-

ASSEMBLY:



Please read all instruction before beginning assembly.

The illustrations provided allow for easier assembly

when used in conjun

ction with the assembly instructions.



Remove all parts and hardware from box and lay out on a carpeted or scratch

-

free work

surface,

as t

his will

avoid damaging any parts during assembly. The shipping box provides and ideal work surface

.

Do not dispose

of

any contents until assembly is completed to avoid accidentally discarding small parts or hardware.



For your safety and

ease, adult assembly

by t

wo people is recommended.



Save all packing materials until assembly is complete to avoid accidentally discardin

g smaller parts or

hardware.



Use the parts and hardware lists to identify and separate each of the pieces included prior to starting

assembly.



Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may caus

e the

bolts to misalign during assembly.



If using power tools to aid in assembly please use caution. Power tools can damage hardware or split wood.

PARTS INCLUDED:

(A)

Table Top

-1pc(B

) Leg

s-4pcs

TOOLS

REQUIR

ED:

Phillips head screwdriv

er (not included)

HARDWARE

ENCLOSED

:(C)Ø

10x48mm Nuts

-4pcs(D)1/4x76mmBolts

-8pcs

(E) Washer 1/4mm

–

8pcs

A

B

(F) Spring washer 1/4mm

–

8pcs

(G) Nuts 1/4mm

–

8pcs

(H) Spanner

–

1pc

ASSEMBLY

INSTR

UCTIONS

:1.Insert the Bolts (D) into the pre

-

drilled holes on Leg (B) as shown. Insert the Bolts (D) into the pre

-

drilled holes

on the top of the leg (B) to receive the Nut (C). Tighten with a screwdriver, but do not over tight.

Repeat same

process for

the other 3

L

egs. (Fig. 1)

.

(Fig. 1)

2.

Lay tabletop (A) face down on your work surface and position one of the Desk legs (B) exactly as shown in

illustration below.

Align the pre

-

drilled holes in each leg with the pr

e-drilled holes in the corner braces of the

table top.. Insert 1 Flat washer (E) and 1 Spring washer (F) and 1 Nut (F) per leg as shown.

Fully tighten with

the enclosed spanner (H).

Repeat same process for the other 3 legs. (Fig.

2)(Fig.

2)

B

CDABHEF

G