Pottery Barn Farmhouse Activity Cart Assembly Instruction
pottery barn kids
FARMHOUSE
ACTIVITY
CART
WARNING:
FALL HAZARD
–
To prevent death or serious injury from falls, always
keep child within arm’s reach. NEVER LEAVE CHILD UNATTENDED and always use restraining system.
This changing table is int
ended for use with children weighing up to 50 pounds.
Do not use the changing table if it is damaged or broken.
PRE
-
ASSEMBLY:
Please read all instruction before beginning assembly.
The illustrations provided allow for easier assembly
when used in conjunc
tion with the assembly instructions.
Remove all parts and hardware from box and lay out on a carpeted or scratch
-
free work
surface,
as t
his will
avoid damaging any parts during assembly. The shipping box provides and ideal work surface
.
Do not dispose
of a
ny contents until assembly is completed to avoid accidentally discarding small parts or hardware.
For your safety and
ease, adult assembly
by t
wo people is recommended.
Save all packing materials until assembly is complete to avoid accidentally discarding
smaller parts or
hardware.
Use the parts and hardware lists to identify and separate each of the pieces included prior to starting
assembly.
Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause
the
bolts to misalign during assembly.
If using power tools to aid in assembly please use caution. Power tools can damage hardware or split wood.
PARTS INCLUDED:
(A)
Front panel
-1pc(B)Back panel
-1pc(C)Left & Right panel
-2pcs(D)
Bottom
panel
-2pc
TOOLS
REQUIR
ED:
Phillips head screwdriver (not included)
HARDWARE
ENCLOSED
:(E)1/4x25mmBolts-8pcs(F)Caster
-4pcs(G)3.5x15
mm
Screws
–16pcs
ABC
D
(H) 4mm
Allen key
–
1pc
ASSEMBLY
INST
RUCTIONS
:
1.
Lay the Bottom panel (D) on your work surface with the side of the pre
-
drilled holes facing up. Insert the Caster (F) into
the pre
-
drilled holes on the Bottom panel by using #3.5 x 15mm screw (G). (Fig. 1)
(Fig. 1)
2
. Position the Front panel (A), exactly as shown in illustration below. Attach the Side panels (C )
by insertin
g the
1/4
x25mm Bolts (E) into pre
-
drilled holes located in the Front panel, tightening with Philips screwdriver. Repeat the
s
ame process for the other side panel.
(Fig. 2)
DFGAC
E
Loading...