Pottery Barn Darcy Twin and Full Bed Assembly Instruction

pottery barn kids

DARCY BED TWIN/FULL

PRE-ASSEMBLY:

• Read all instructions before beginning assembly. The illustrations provided allow for easier assembly when used
in conjunction with the assembly instructions.

• For your safety and ease, assembly by two adults is recommended.

• Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work surface. Use

care as some parts or hardware may have sharp points or edges.

• Do not dispose of any contents until assembly is completed to avoid accidentally discarding small parts or
hardware.

• Use the parts and hardware lists to identify and separate each of the pieces included.

• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause the

bolts to misalign during assembly.

• The use of power tools for assembly is not recommended. Power tools can damage hardware or split wood.

PARTS INCLUDED:

A - Headboard (1pcs) B - Footboard (1pcs)

C - Side Rail (2pcs)

HARDWARE INCLUDED:

E - Wood Screw, 8 x 30 mm (32 pcs)

TOOLS REQUIRED:
Phillips Head Screwdriver (Not included)

D - Slat Roll (1pcs) F - Finial (4pcs)

Page 1/3

ASSEMBLY INSTRUCTIONS:

1. Attach the Side Rails (C) to the Headboard (A) and Footboard (B) by inserting the hooked ends into the
corresponding slots. Ensure that the connections are secure.

NOTE: Side Rails (C) are adjustable to two heights:

z Use the higher setting if not using a box spring mattress and/or if a trundle will be used with the bed.
z Use the lower setting if using a mattress & box spring. We recommend a box spring if you want to use a

bedskirt/box spring cover or add height to the bed.

z Our beds do not require a box spring at either setting

There are three (3) pins inside the slot, for two

A

Figure 1

(2) levels of side rail height.

High level: insert side rail onto 2 upper pins
Low level: insert side rail onto 2 lower pins

B

C

C

2. Lay Slat Roll (D) in place onto the inner edges of the Side Rails (C), and secure with Wood Screws (E) using the

Phillips Head Screwdriver (not included).

Figure 2

E

D

Page 2/3