
Chloe Coffee Table
Assembly Instructions
Pre-Assembly:
• Please read all instructions carefully before
beginning assembly
• This table requires two people to do the
assembly.
• Do not fully tighten all bolts until all parts are in
place. Failure to follow these instructions may
cause the bolts to misalign or may cause
difficulty during assembly.
• Use the parts and hardware lists to identify and
separate each of the components included.
• Save all packing materials until the table is fully
assembled to avoid accidentally discarding any
small parts or hardware.
Parts Included:
(1) Tabletop - A (1) Shelf – B (4) Legs - C
Hardware Included:
(12) Flat Washer - D (12) Lock Washer - E (8) Allen Head Bolt
(M6 x 60 mm)- F
(4) Nut - H (4) Fitting - I
(1) Allen Wrench (3 mm
thickness) - J
1/5
(1) Allen Key - G

Assembly Instructions:
1. Insert the hanger bolt pre-connected to the leg (C) into the pre-drilled corner hole of the shelf (B). Insert fitting
(I), flat washer (D), lock washer (E), and nut (H) into the bolt. Use hand to secure. DO NOT FULLY TIGHTEN AT
THIS TIME. (Fig. 1)
H
E
D
I
B
2. Repeat step 1 with one leg (C) at the other end. (Fig. 2)
H
E
D
I
C
Fig. 1
C
B
Fig. 2
C
2/5

3. Turn the assembled leg and shelf up and attach one leg (C) to the shelf from underneath as shown. Insert fitting
(I), flat washer (D), lock washer (E), and nut (H) into the bolt. Use hand to secure. DO NOT TIGHTEN FULLY AT
THIS TIME. (Fig. 3)
H
E
D
Fig. 3
I
B
C
4. Attach the remaining leg (C) to the shelf (B) using step 3 instructions. (Fig. 4)
H
E
D
I
C
B
Fig. 4
3/5

5. Lay the tabletop (A) upside down on a carpeted or scratch-free work surface (the foam shipped in the carton
box works well). Attach the legs with the shelf by aligning the legs with the corner braces on the tabletop (A).
(Fig. 5)
A
Fig. 5
6. Insert a lock washer (E) and a flat washer (D) into Allen bolts (F). Insert bolts with washers through the pre-
drilled corner holes of the tabletop (A) and into the legs (C). Use hand to screw half way then secure using the
Allen key (G). (Fig. 6)
G
D
E
F
Fig. 6
Keep the long end of key
Use the long end of the Allen
for easy securing
key for easy securing
Loosen Tighten
Loosen Tighten
4/5

7. Use the Allen wrench (J) to tighten the nuts (I). (Fig. 7)
J
Fig. 7
I
Loosen Tighten
Loosen Tighten
8. Grip the table on both ends and carefully turn upright. Assembly is complete. (Fig. 8)
Fig. 8
Care Instructions:
• For daily cleaning, wipe with a soft damp cloth.
• Wipe up spills immediately.
• Avoid the use of chemicals and harsh cleaning agents.
• The use of trivets and coasters is recommended to protect the tabletop.
thank you for your purchase
stores | catalog | www.potterybarn.com
5/5