Pottery Barn Camp Media Hutch Assembly Instruction

pottery barn kids

CAMP MEDIA WALL HUTCH

CAUTION

The top shelf of this cart/stand is intended for use with:
Plasma/LCD/DLP/HD televisions having a maximum screen size of 45 inches and weight of 100 lbs.
All other support shelves should not be loaded more than 25 lbs.

DO NOT EXCEED RECOMMENDED LOAD. Use with products heavier than the maximum sizes and
weights indicated may result in instability causing possible injury.

This unit contains a permanent sticker located either beneath media support shelf or inside drawer.
Do not allow children under 16 years to move cart.

MISE EN GARDE

L’étagère supérieure de ce support ou chariot est destinée à recevoir :
une télévision à écran plasma ou haute densité dont l’écran ne mesure pas plus de 114 cm et qui ne
pèse pas plus de 45.4 kg.
Les autres étagères ne doivent pas recevoir une charge de plus de 11 kg.

NE PAS DÉPASSER LA CHARGE RECOMMANDÉE. L’utilisation avec des articles qui dépassent la
taille et le poids recommandés peut rendre l’article instable et entraîner des blessures.

Cet article comprend un autocollant permanent, placé soit sous l’étagère supérieure, soit à l’intérieur
du tiroir.

Il faut interdire à tout enfant de moins de 16 ans de déplacer le chariot

PRE-ASSEMBLY:

• For your safety and ea se, assembly by two adults is reco mme nded.

• Please read all instructions before beginning assembly. The illustrations provided allow for easier assembly

when used in conjunction with the assembly instructions.

• Remove all parts and hardware from box and lay out on a carpeted or scratch-free work surface. The shipping
box provides and ideal work surface. Do not dispose of any contents until assembly is completed to avoid
accidentally discarding small parts or hardware.

• Use the parts and hardware lists to identify and separate each of the pieces included prior to starting
assembly.

• Note: DO not fully tighten the bolts until all parts are in place. Failure to follow these instructions may cause
the bolts to misalign during assembly.

• If using power tools to aid in assembly please use caution. Power tools can damage hardware or split wood

.

Page 1/3

PARTS INCLUDED:
(A) Media Wall Hutch – 1pc

(B) Removable Shelf – 2pcs

PARTS REQUIRED:
Camp Media Wall Base (Sold Separately)

TOOLS REQUIRED:

HARDWARE INCLUDED:

(C) Shelf Support Peg – 8pcs

(D) Short Wood Screw 3.5 x 12mm

Philips Screwdriver (Not included)

(E) Connecting Bracket – 2pcs

– 4pcs

ASSEMBLY INSTRUCTIONS:

1. Insert (4) Shelf Support Pegs (C) into the pre-d rilled holes on interior sides of the Left/R ig ht Side Panels o f

the Media Wall Hutch at the desired height. Place Removable Shef (B) on the Shelf Support Pegs (C).
Repeat with second shelf.

NOTE: Support shelves should not be loaded more than 25 lbs.

B.

Page 2/3