Package Contents
RT-5015 15” fanless touch terminal or
RT-5016 15.6” fanless touch terminal or
RT-5115 15” fanless touch terminal or
RT-5116 15.6” fanless touch terminal (x 1)
Power adapter (x 1)
Power cord (x 1)
User manual (x 1)
16940900010 Ver. A0
http://www.posiflex.com
RT-5015/5016/5115/5116
Fanless Touch POS Terminal
User Manual
1
Views of RT-5015/5016/5115/5116
Front View
15” RT-5015/5115 15.6” RT-5016/5116
Rear View
Bottom View
System Back Cover
Stand Cover
Cable Exit
RT-5015/5016/5115/5116
P-Cap Touch Panel
LED indicator
LED indicator
Base Stand
Camera (Optional)
Attachment Bay
Release Lever for System Back Cover
Screw for Fire-Resistant
System Back Cover
2
Left-Side View
View of I/O Interface of RT-5015/5016/5115/5116
Positioning your POS for a Perfect Viewing Angle
Steady the base with one hand, and then tilt the screen
in the direction shown by the arrow in the figure.
Please do NOT press on the LCD panel while
setting up the tilt angle.
Power Button
Brightness Adjustment Button ＋
Brightness Adjustment Button －
USB 3.0 Ports
DB9 COM Port
CR Port
LAN Port
DC IN
Power
Connector
Mini DisplayPort
RJ50 COM Ports
USB 2.0 Ports
3
Installing Power Adapter and Cables
The following provides instructions required to install your cables.
1. Lay the terminal with its rear facing
towards you and tilt the screen all the way
down.
2. Remove the system back cover.
2.1 If the system back cover is fire-resistant, first locate the screw as
indicated in the figure, and then remove it.
2.2 Hold down the release lever at the bottom of
the system back cover and then pulling the
cover outwards.
3. To remove the stand cover from the base, grab the top side of the
cover, (1) lift the stand cover up gently, (2) pull it at a 45 degree
angle, and then (3) slide it in the horizontal direction shown by the
arrow.
1 2 3
Screw for Fire-Resistant
System Back Cover
4
4. Connect the connector of the power adapter
to the DC-IN power jack. If necessary,
properly insert other cables into the correct
port.
5. Neatly arrange the cables. Locate the cable holder inside the base as
shown in the figure. Push down the lever to release if from the hook,
pass the cable through cable holder, and then press down the lever
again to lock it onto the hook.
6. Make sure the cord can be held into place
and passed through the cable exit after
sliding back the stand cover.
7.
7.1 Place back the sytem back cover. Make sure
it is well locked into place with a click sound.
7.2 For the fire-resistant system back cover, please insert another
screw into the screw hole indicated in the figure, and secure it.
Cable holder
Screw for Fire-Resistant
System Back Cover
5
Loading...