Part 1
FCC NOTICE
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions manual, may cause interference to radio communications. It has been tested and found to comply with limits for a Class
A digital device pursuant to subpart J of Part 15 of FCC Rules, which are designed to provide reasonable protection against
interference when operated in a commercial environment. Operation of this equipment in a residential area is likely to cause
interference in which case the user at his own expense will be required to take whatever measures to correct the interference.
WARRANTY LIMITS
Warranty will terminate automatically when the machine is opened by any person other than the authorized technicians. The user
should consult his/her dealer for the problem happened. Warranty voids if the user does not follow the instructions in application of
this merchandise. The manufacturer is by no means responsible for any damage or hazard caused by improper application.
ABOUT THIS MANUAL
This manual assists the user to utilize the Touch Monitor LM-2310/LM-2210. This product provides exquisite touch control
capability over a stable and adjustable LCD monitor with minimal footprint.
The manufacturer of the LM-2310/LM-2210 monitor heartily apologizes to the user for reserving the right to change or to modify
this manual without notice due to the rapid and constant progress and improvement on science and technology. The user may
always obtain the most up to date information through any of our web sites: http://www.posiflex.com, http://www.posiflex.com.tw,
http://www.posiflexusa.com.
Copyright Posiflex Technology, Inc. 2012
TRADE MARKS AND SERVICE MARKS
POSIFLEX is a registered trademark of Posiflex Technology, Inc.
Other brand and product names are trademarks and registered trademarks and service marks of their respective owners.
I. FEATURES
• LM-2310/LM-2210 is principally designed for Posiflex KS-series POS
solutions
• 10” LCD monitor with tilt adjustment for industrial and commercial use
• High quality TFT LCD panel.
• Easy maintenance structure allowing easy cleaning
• Super VGA monitor resolution up to 800 x 600 pixels
• Support power supply through LCD cable from Posiflex Terminal to
operate without power adaptor
LM-2310/2210
LCD Monitor
User’s Manual
Rev. Original
P/N:
1
9610900010
Part 2
II. PARTS IDENTIFICATION
A. FRONT VIEW (LM-2210/LM-2310)
B. REAR VIEW (LM-2210/LM-2310)
C. SIDE VIEW (LM-2310)
Display Screen
Power LED
Main Unit
Stand
VGA Connector and
DC jack
Control button area
OSD button
NXT button
“+” button
“-“ button
Power switch
Hinge
Main Unit
Base Stand
Cable Exit
Joint Bracket
Part 3
Control button area
VGA Connector and
DC jack.
NXT button
“+” button
OSD button
“-“ button
Power switch
C. SIDE VIEW (LM-2210)
D. POWEPOWER LED INDICATION
• Green: standby (no signal)
• Blue: operating
Before routing the cable, please release the hooks
Of stand’s back cover as arrowed in the right
picture. For cable routing in mini slim base,
please refer to the picture
at left. There are 2 cable
tie holder slits on the
metal bracket for the
trunk as arrowed in the picture. Hold all the external
cables with a cable tie through the right cable tie holder
slit and leave the cables to the left holder slit. Have all
cables to pass through the oval hole on the trunk to come out of the front side
of trunk. Connect all the cable ends to main unit. Be sure not to damage any
cable during this operation.
CABLE ROUTING IN BASE (LM-2210)
Loading...