Posey Gap Fillers User Manual



BED SAFETY

FDA/HBSW Entrapment Zone Mitigation

The Posey Gap Fillers may be useful in addressing FDA/
HBSW identified entrapment zones 1, 2, 3, 4, and 7 on
many Hospital/LTC/Homecare bed systems. Posey
recommends using the HBSW specified bed system
measurement tool to determine actual compliance of any
installation. For more information, visit http://www.fda.
gov/MedicalDevices/DeviceRegulationandGuidance/
GuidanceDocuments/ucm072662.htm

Posey Gap Fillers easily fit around the perimeter of the
mattress to help eliminate gaps between the mattress and
the bed headboard/footboard/side rails to prevent potential
entrapment. Zippers allow you to connect multiple Gap
Fillers and create a custom length. Three pairs create a
border around most mattresses. Made of soft, durable
foam. Vinyl cover wipes clean. Meets CA #117, Section E
Flame Retardancy Standards.

REF

5715 Gap Fillers, one pair: 35”L x 6”H x 2”D

(89 cm x 15 cm x 5 cm)

Posey

Fig. 1

®

Gap Fillers

Monitoring

Posey Gap Fillers will not prevent a determined
patient from exiting the bed, going over or attempting to
go between or through side rail gaps. DO NOT articulate
bed if product is applied. ALWAYS follow your facility’s
policies and procedures for patient assessment, monitoring
and rehabilitation.

Application Instructions:

1. Inspect product prior to use. DO NOT use soiled or

damaged products.

2. Position the Gap Filler with the label towards the

bottom and the zipper away from the mattress.

3. At the selected location, slide the Gap Filler between

the mattress and the side rails (Fig. 1) or the head
footboard (Fig. 2).

4. Top of Gap Fillers should not fall below the top surface

of the mattress.

5. Gap Fillers should have a snug fit and should not be able

to slide out of place.

6. If the gap you are trying to fill is wider than 2 inches
(5 cm), multiple Gap Fillers can be zipped together to fill

in the gap (Fig. 3).

7. Check for proper fit. Modified beds may not be

compatible with Posey Gap Fillers.

Fig. 2 Fig. 3

Cleaning Instructions:

Wipe Clean with soap and water or
disinfectant.

Disposal

Properly dispose of the product per facility’s

policy for BIOHAZARDOUS materials.

Storage and Handling

This device is designed for use in normal indoor
environments. This device may be stored in ambient
warehouse temperatures at normal humidity levels.
Avoid excess moisture or high humidity that may
damage product materials.

Refer to the Posey Catalog for the Posey product/bed
cross-reference guide to check for compatibility with
certain bed models.

Posey Company • 5635 Peck Road, Arcadia, CA 91006-0020 USA • www.posey.com
Phone: [phone] or 1.626.443.3143 • Fax: [phone] or 1.626.443.5014

© 2012 Posey Company. All rights reserved.

M6024 REV C 080712