Portos XT-R Instruction Manual

R

INSTRUCTION

MANUAL

XT-R

Flush mounted
radio receiver

Technical data:

Nominal voltage: 230V, 50Hz
Nominal current: 5A
Ambient temperature: -25 to +85
Dimensions: 44 mm x 44 mm x 25 mm

PORTOS Sp.J.
ul. Złota 71

62 - 800 Kalisz
tel. [phone]
[e-mail]
www.portosrolety.pl

Controller functions:

The device allows to control one
tubular motor. It has a built-in
receiver compatible with all 433
MHz PORTOS radio transmitters
and a possibility to attach a
pushbutton*. The controller can be
installed in a gang box.

* only pushbutton without support
and the possibility to press
simultaneously both buttons

Setting switch

Programming of the controller

2

There are two possible ways of setting the receiver:
Setting via a remote – if there is a possibility to switch off and on the power supply for each motor
separately
Setting via the setting switch – when there is no possibility to disconnect each motor separately from
the power supply

st

Programming a remote (1 method)

1. Choose the channel on the remote that You want to program.

2. Switch on the power supply (confirms with short movement).

3. Press the P2 button on the active channel of the remote. The receiver enters the programming
mode (LED is flashing and You can hear a beep ).

4. Press the P2 button on the remote twice and after that Up or DOWN button, depending on the side
the motor is mounted in the roller shutter.

5. The receiver confirms the programming by short movement of the roller shutter and finishes the
programming procedure (LED switches off as well as the beep).

rd

Programming a remote (2 method )

1. Choose the channel on the remote that You want to program.

2. Press the setting switch on the receiver for 3 seconds. The device enters the programming mode (
confirms with a short movement and a beep).

3. Press the P2 button on the remote twice and after that Up or DOWN button, depending on the side
the motor is mounted in the roller shutter.

4. The receiver confirms the programming by short movement of the roller shutter and finishes the
programming procedure (LED and beep switch off).

st

Removing the controller settings from a particular channel (1 method)

(the receiver needs to be programmed already)

1. Choose the channel on the remote that You want to remove the receiver from.

2. Switch on the powers supply to the receiver (confirms with short movement)

3. Press the P2 button on the particular channel of the remote. The receiver enters the
programming mode (LED is flashing and You can hear a beep)

4. Press the P2 button on the remote (confirms with a short movement)

5. Press the STOP button on the remote (confirms with a short movement)

6. Press the P2 button on the remote (confirms with a short movement)

7. The receiver confirms the removing by short movement of the roller shutter and finishes the
programming procedure (LED and the beep switch off)

rd

Removing the settings from a particular channel (2 method )

(the receiver needs to be programmed already)

1. Choose the channel on the remote that You want to remove the receiver from.

2. Press the setting switch on the receiver for 3 seconds. The device enters the programming

mode (confirms with a short movement and a beep)

3. Press the P2 button on the remote (confirms with a short movement).

4. Press the STOP button on the remote (confirms with a short movement)

5. Press the P2 button on the remote (confirms with a short movement).

6. The receiver confirms the removing by short movement of the roller shutter and finishes the
programming procedure (LED and the beep switch off).

Removing the settings