Portos RR-5T Instruction Manual

R

INSTRUCTION MANUAL

RR-5T

Transmitters operate
on frequency
433 Mhz

Specification :

Nominal voltage: 3V
Battery type: CR 2430
Radio frequency: 433 Mhz
Transmit power: 10 mW
Ambient temperature: from -10 ˚C to +50 ˚C
Operating range: 150 m outside buildings

25 m indoors

PORTOS Sp.J.
ul. Złota 71

62 - 800 Kalisz
tel. 62 / 768 40 00
[e-mail]
www.portosrolety.pl

Characteristics of the device:

!!!

RR-5T

man

auto

Mode

The direction
of movement

UP

STOP

DOWN

CHANNEL UP

CHANNEL DOWN

P2

CR 2430

3V

MODE

TIME

P2

BATTERY

Active

channel

Time

MODE

TIME

Switch the electricity ON. The motor will make a short beep and will vibrate ( short
movement up & down ). The motor is in programming mode for 12 seconds. If no button
will be pushed within these 12 seconds the motor leaves the programming procedure.

Choose the channel that You wish to program ( for remotes with more than one
channel ).

1.Press the P2 button, the motor will emit a single sound.

2.Press again P2 button. The motor will only emit a single sound.

3.Press either button Up or DOWN. The programming will be confirmed by 6 short beeps
and after that the motor will vibrate, meaning that the programming was successful.

The programming on the channel

!!!

CAUTION!!

When programming, only the tubular motor which is to be programmed
needs to be power supplied.

2

After the programming procedure is finished You need to verify the directions on the
remote by simply starting the motor. If the directions are swapped then the programming
procedure needs to be done once more, eg:
If the motor has been programmed using the procedure two times P2 and then DOWN
button and the directions are swapped, then we need to program the motor again using
the opposite procedure, meaning two times P2 and then UP button.

ON

P2

MODE

TIME

P2

MODE

TIME

ON

P2

MODE

TIME

P2

MODE

TIME

man

auto

man

auto