Portos PX1, PX5, PX15 User Manual

Technical data :

Power: 3V battery ( CR 2430 )
Operating frequency: 433 MHz
Transmission power: 10 mW
Operating temperature: from -10 ˚C to +50 ˚C
Operating range: Determined by architectural

and regulatory factors

Device characteristics:

PX15 (15 channels)

USER MANUAL

PX1, PX5, PX15

PORTOS drive controlling system

The remotes operate
at 433 MHz
frequency

UP

STOP

DOWN

CHANNEL

NUMBER

CHANNEL -

CHANNEL +

BATTERY

SLOT

P2

2

PX5 (5 channels)

PX1 (1 channel)

UP

STOP

DOWN

CHANNEL -

CHANNEL +

BATTERY

SLOT

P2

UP

STOP

DOWN

BATTERY

SLOT

P2

1. Programming the radio drive on a specific channel of any
transmitter.

IMPORTANT!!!

While programming, only the drive being programmed should be
connected to a power supply.

A. Method one

In order to program the drive, open the inspection hatch of the roller shutter and:

1. Press the microswitch located on the lead emerging from the head of the drive for 1

second – the motor will confirm with a single beep sound and the shutter will move
briefly UP and DOWN.

2. Using the CHANNEL + / - buttons, select the channel you want to program and press
P2 – the motor will make a single beep sound.

3. Press P2 again, the motor will make a single beep sound again.

4. To finish the programming process, press UP. You will hear 6 beeps and the roller
shutter will move briefly up and down.

B. Method two

After connecting the motor to a power supply, you will hear a long single beep sound
and the motor will move briefly up and down (if you do not press any button within
12 seconds, the motor will quit the programming mode).

1. Using the CHANNEL + / - buttons, select the channel you wish to program:

2.Press the P2 button, the motor will make a single beep sound.

3.Press P2 again, the motor will make a single beep sound again.

4.Press the UP button, the motor will make 6 beeps and move briefly up and down,
which means that the channel has been programmed.

3