PORTMAN ELECTRONICS T53 915, RX04 915, T89 915 User Manual

PORTMAN SECURITY SYSTEMS, LTD

TWO-WAY CAR ALARM

Operation/ Installation Manual

AM9600---T89/T53/RX04

10/20/2012

Version 1.1

1

4

T89(Two way)

1
2

3

7

6

5

7

6

T53(One way)

1
2

3

5

4

charge

T89 T53
(Two way) (One way)

Functions

Conditions

Press button 1 once

Arm and lock doors
Car finder with
sound
Stop alarm
temporarily
Remote lock doors

Disarmed and Ignition
OFF
Armed
Sounding
While driving

Press and hold button 1 for 2 sec.

Remote Panic

Anytime

Press button 2 once

Disarm/unlock
Stop alarm
temporarily
Remote unlock
doors

Armed
Sounding
While driving

Press and hold button 2 for 2 sec.

All door
unlock/disarm

Arming

Press and hold button 3 for 2 sec.

Open trunk
(Channel 1 output)

Anytime

2

Press button 4 once then press button 1
within 3 sec.

Active anti car
hijacking

While driving
Channel 2 output

Anytime

Press button 4 once then press button 3
within 3 sec.

Channel 3 output

Anytime

Press button 4 once then press button 4
within 3 sec.

Channel 4 output

Anytime

Press and hold button 4 for 2 sec.

Remote start on/off

When start procedure
ready

Press button 1 + 4 once together

Arm with bypass
shock sensor

Disarming and ignition
OFF

Press button 3 + 4 once together

Manual active ready
mode

Ignition on & disarming
& handbrake on

Press button 5 once then press button 1
within 3 sec.

Silent arm

Disarmed and ignition
OFF

Press button 5 once then press button 2
within 3 sec.

Silent disarm

Arming

Press button 5 once then press button 3
within 3 sec.

Silent arm with
bypass ext. sensor

Disarmed and ignition
OFF

Press button 5 once then press button 4
within 3 sec.

Timer start on/off

When start procedure
ready

Press button 5 once then press button 5
within 3 sec.

Valet mode on/off

Disarming

Press button 5 once then press and hold
button 1 for 2 sec. within 3 sec.

No alarm arm mode

Disarmed and ignition
OFF

Press button 1+3 for 2 seconds(Only
T89)

Transmitter power
off

Transmitter power on

Note: press button 6 can control different main unit 。

Receiver RX04

3

CANBUS FUNCTION

1. ARM IN +: This input wire is normally connected to the vehicle’s CANBUS

interface. The system will enter arming mode when it detected arming signal from
the CANBUS interface.

2. DISARM IN +: This input wire is normally connected to the vehicle’s CANBUS

interface. The system will enter disarming mode when it detected disarming signal
from the CANBUS interface.

3. Hood trigger -: This input wire is normally connected to the vehicle’s CANBUS

interface. The system will alarm in arming mode when it detected hood trigger
signal from the CANBUS interface.

4. Ignition input +: This input wire is normally connected to the vehicle’s CANBUS

interface. If it detected ignition trigger signal from the CANBUS interface, then the
system will alarm in arming mode, and the system will enter driving mode in
disarming mode.

5. Door trigger -: This input wire is normally connected to the vehicle’s CANBUS

interface. The system will alarm in arming mode when it detected door trigger
signal from the CANBUS interface.

6. Trunk trigger -: This input wire is normally connected to the vehicle’s CANBUS

interface. The system will alarm in arming mode when it detected trunk trigger
signal from the CANBUS interface.

4

PC SETUP FUNCTION

When unit is in disarming & Door open status, Select the correct COM port number, and
then set the following functions

5

Default: to use factory default setting
Request: read out the setting in the current page.
Apply: transfer the setting to unit in the current pages.
Exit: exit PC-Setup program.

BASIC CAR ALARM FUNCTION DESCRIPTION
CODE LEARNING

a. When in disarmed mode.
b. Turn ignition ON, press Valet Switch 10 times within 8 seconds, siren will chirp 3

6

times, system will enter code-learning mode.

c. Press any button on the transmitter, the siren will chirp accordingly for confirmation

as soon as the transmitter is learned. For example, if the first transmitter is learned,
the siren will chirp once. If the second transmitter is learned, the siren will chirp
twice, etc…

d. Up to 3 transmitters can be programmed.
e. If one of the transmitters is programmed, the other transmitters must be

reprogrammed within 8 seconds. Turn ignition OFF or 8 seconds later, system will
exit code- learning mode.

ARMING

a. Press button 1.
b. Siren will chirp once. Parking lights will flash once.
c. Disables engine starter.
d. The doors will be locked after 0.5 seconds or 3.5 seconds. (see function selection J1-

1)

e. Two-way transmitter will chirp once.
f. LED will flash slowly
g. After 3 seconds, all the sensors are armed. If the alarm shock sensor is triggered

within 3 seconds, the siren will chirp twice and the circuit will be by-passed. Alarm
will rearm by itself only when the sensor is stable for 2 seconds.

h. If doors, trunk, hood are not closed enter arm, siren will chirp 5 time.

ARMING WITH BYPASSING SHOCK SENSOR

a. Press button 4 and button 1 together once
b. Siren will chirp once then long chirp once and parking light will flash once, the

system is entry in armed mode, all sensors will be bypassed in this arming cycle.

SILENT ARMING

a. In disarming state,press button 5 once then press button 1 once within 3 seconds.
b. Parking light will flash once.
c. Disables engine starter.
d. Door will be locked at 0.5seconds or 3.5 seconds (See Function Selection J1-1).
e. After 3 seconds, all the sensors are armed. If the alarm shock sensor is triggered

within 3 seconds, the siren will chirp twice and the circuit will be by-passed. Alarm
will rearm by itself only when the sensor is stable for 2 seconds.

f. LED will flash slowly.

7

SILENT ARMING WITH BYPASSING SHOCK SENSOR

a. In disarming state, press button 5 once then press button 3 once within 3 seconds.
b. Parking light will flash once, the system is entry in silent armed mode, all sensors

will be bypassed in this arming cycle.

HIDDEN ALARM ARMING

a. First press button 5 then press and hold button 1 for 2 seconds within 3 seconds
b. Siren will chirp twice and parking light will flash twice, the system will entry in no

alarm arming mode.

c. In this arming mode, the siren and parking light will not alarm if any sensor will be

triggered, but the system will remain send trigger signal to the transmitter.

ALARM PERIOD AND SOUNDING CYCLE

a. While arming, if any detector is triggered, the siren will sound 30 seconds (max) and

the parking light will flash 30 seconds (max).

b. For any single trigger, the siren will sound one cycle only. (One cycle is: sound 30

seconds and stop 3 seconds.)

c. For the same arming period, and for each single detector, the system can only be

triggered (single trigger) at most 8 times.

d. For each individual detector, the number of sounding cycle can be accumulated in

the same arming period. (E.g. If open the door, and let the siren sound 5 cycles, and
close the door, the siren will stop sound, then if open the door again, it can only
sound 3 cycles.)

e. After 8 cycles, the triggered detector will be bypassed. This detector will not be

triggered again in the same arming period.

f. The system is disarmed; the all the detector is return normal status.

TRANSMITTER DISPLAY REPORT WHEN SYSTEM TRIGGER

a. The system is in arming status.
b. If the shock sensor is warned triggered, piezo will continue sound.
c. If the shock sensor or ext sensor is fully triggered, the unit will send the information

to transmitter, piezo will continue sound.

d. If the door is triggered, the unit will send the information to transmitter, piezo will

continue sound.

e. If ignition has been triggered, the unit will send the information to transmitter, piezo

8

will sound continually.

f. If the trunk is triggered, the unit will send the information to transmitter, piezo will

continue sound.

g. If the hood is triggered, the unit will send the information to transmitter, piezo will

continue sound.

h. The transmitter alarm display (icon flash and piezo sound) will continuously for 30

seconds (max), within 30 seconds, press button 1 or button 2 will stop alarm.

DISARMING

a. Press button 2.
b. Siren will chirp 3 times, parking lights will flash 3 times. If siren chirps 4 times and

parking lights flash 4 times, which means the alarm has been triggered during arming
state.

c. Press button 3 and button 2 together once the system will silent disarming, only

parking light will flash indication.

d. Doors will be unlocked after 0.5 seconds or 3.5 seconds (see function selection J1-1).
e. If somewhere was triggered, the LED will flash to indicate as following:

Quick flash 2 times after a pause Shock sensor or ext sensor full trigger
Quick flash 3 times after a pause Door trigger
Quick flash 4 times after a pause Trunk trigger
Quick flash 5 times after a pause Hood trigger
Quick flash 6 times after a pause IGN trigger

f. Dome light will be ON for 30 seconds (if selective dome light output), and will be

OFF when ignition ON.

AUTOMATIC REARMING (SEE FUNCTION SELECTION J1-7)

After disarm, the system will be re-armed automatically or re-arm with door lock after 30
seconds if the ignition does not turn ON or the door is not open.

LAST DOOR ARMING (SEE FUNCTION SELECTION J1-6)

a. Turn ignition ON, then OFF and close the last door. After 30 seconds, the system

will arm automatically or arm with door lock.

b. If one of the doors is opened during the above mentioned 30 seconds periods, system

will postpone enter arming mode till all doors are closed.

9

SMART IMMOBILIZATION (SEE FUNCTION SELECTION J1-11)

a. When ignition is turned to OFF for 2 min, if the alarm is not armed, the engine will

be cut automatically and cannot be restarted. LED will be ON for 0.5 seconds and
then OFF for 3 seconds, and circle.

b. Exit auto-immobilization mode: when ignition OFF, press button 2 once, Or please

perform OVERRIDE PROCEDURE.

2-STAGE SENSOR

a. If car receives a light shock, siren will chirp five times and parking lights will flash

once for warning purpose.

b. If car receives a heavy signal, siren will sound and parking lights will flash for 30

seconds immediately.

DOOR LOCK CONTROL (WHILE DRIVING)

a. Press button 1 to lock doors. The doors can be locked.
b. Press button 2 to unlock doors. The doors can be unlocked.

AUTOMATIC DOOR LOCK (SEE FUNCTION SELECTION J1-8)

When the system is disarming and the ignition turn from OFF to ON, door will lock after
15 seconds or door will lock with footbrake is press first.

AUTOMATIC DOOR UNLOCK (SEE FUNCTION SELECTION J1-9)

When the ignition turns from ON to OFF, doors will automatically unlock.

SECOND UNLOCK (SEE FUNCTION SELECTION J2-4)

If the system is selection second unlock on, press and hold button 2 for 2 seconds, the
second unlock will output 300mA negative signal.

OPEN TRUNK (CHANNEL 1 OUTPUT) (SEE FUNCTION SELECTION J2-3
/J2-8)

a. Anytime, press and hold button 3 for 2 seconds will to open trunk (channel 1 output)

(with 300mA negative output).