Porter & Charles Pyramid-30, Pyramid-36 Instruction Manual

Pyramid-30, Pyramid-36
Range Hood Instruction Manual
Thank you for the purchase of this product. Please read the
manual carefully before operating the appliance.
1 | P a g e
Contents
Important Safety Instructions
2
Introduction
3
Features
3
Installation
4-5
How to Use
6
Grounding Instructions
7
Safety Information
8
Trouble Shooting
9
Electrical Diagram
10
Specifications
11
Cleaning & Maintenance
12
Installation Diagram
13
Warranty
14
2 | P a g e
Important Safety Instructions
Read and save these instructions Warning - To reduce the risk of fire or electric shock, do
not use this fan with any solid-state speed control device.
CAUTION: For general ventilating use only. Do not use
to exhaust hazardous or explosive materials and vapors.
Warning - To reduce the risk of a range top grease fire:
Never leave surface units unattended at high settings.
Boil overs cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings.
Always turn hood ON when cooking at high heat or
when flambéing food (i.e. Crepes Suzette, Cherries Jubilee, Peppercorn Beef Flambé)
Clean ventilating fans frequently. Grease should not be
allowed to accumulate on fan or filter.
Use proper pan size. Always use cookware appropriate
for the size of the surface element.
Warning - To reduce the risk of injury to persons in the
event of a range top grease fire, observe the following:
Smother flames with a close-fitting lid, baking sheet, or
metal tray, and then turn off the burner. Be careful to prevent burns. If the flames do not go out immediately, evacuate and call the fire department.
Never pick up a flaming pan - you may be burned. Do not use water, including wet dishcloths or towels a
violent steam explosion may result.
Use an extinguisher ONLY if: A) You know you have a
class ABC extinguisher, and you already know how to operate it. B) The fire is small and contained in the area where it started. C) The fire department is being called. D) You can fight the fire with your back to an exit.
3 | P a g e
Introduction
o This appliance has been manufactured with materials
and processes that respect the environment. We hope that you will continue this important consideration in the operation of this appliance and the disposal of the packaging materials – thank you.
o The installation work must be undertaken by a
qualified technician experienced in range hood installation. Please connect the correct power rating (see page 10)
o The manufacturer disclaims all liability for any damage
or injury caused as a result of not following instructions for installation contained in the following text
o The appliance is not intended for use by young
children or infirm persons without supervision
o Young children should be supervised to ensure that
they do not play with the appliance
o The maximum number of burners covered by a range
hood should not exceed 5
o Any modifications to the appliance, electric wire and
plug is dangerous and voids the warranty
Features
o This appliance is manufactured from top quality
materials, and offers superb streamlined effects
o With high suction power and low noise, it is designed
to remove cooking fumes from your kitchen quietly and effectively
4 | P a g e
Pic 1
Installation (duct is not supplied)
1. The range hood should be mounted at a
distance of 600mm from an electric or induction cooktop, and 762mm above a gas cooktop for safety and optimum performance. If the instructions for installation of the gas cooktop specify a greater distance, this has to be taken into account. (see pic 1) The exhaust air
must not be discharged into a flue which is used for exhausting fumes from other appliances burning gas or other fuels
2. To install onto the wall, drill 2 holes of Ø8mm on a
sturdy wall and in line with the hood
3. Insert expanding screws into the holes
4. Fix drilling template on the wall (see pic 2)
5. Add the soot tube (alternative part) to the one way
valve, and connect it to the kitchen outlet vent. (see pic
3)
6. Insert the outer chimney, the outer chimney should be
fixed on the main body by screws. Then mount the bracket and insert the inner chimney and screw it to tighten. (see pic 4)
600 – 762mm
Loading...
+ 10 hidden pages