Porter&Charles CC76V Operating And Installtion Instructions
OPERATING AND INSTALLATION INSTRUCTIONS
BUILT-IN VITROCERAMIC
COOKTOP
Porter&Charles
CC76V
CONTENTS
1. DESCRIPTION OF THE COOKTOP
2. SAFETY INSTRUCTIONS
3. INSTALLATION
4. ELECTRICAL CONNECTION
5. USAGE
6. TOUCH CONTROL SAFETY FUNCTIONS
7. CLEANING AND CARE
8. WARRANTY&SERVICE
DESCRIPTION OF THE HOB
SAFETY
INSTALLATON
USAGE
Turn On and Turn Off The Control
Select Heater
Turn on dual- and triple zones
Turn Off Individual Zones
Timer Function
Key Lock
Child Lock
TOUCH CONTROL SAFETY FUNCTIONS
Sensor Safety Cut Off
Over Temperature Switch Off
Operating Time Limitations
Residual Heat Functions
CONTENTS:
1
Cooktop
BEFORE USING FOR THE FIRST TIME .
Read the instructions carefully before installing and using the appliance.
After unpacking the appliance, make sure it is not damaged. In case of
doubt, do not use the appliance and contact your supplier or a qualified
technician.
.
Remove all packaging and do not leave the packing material (plastic bags,
polystyrene, bands etc ) in easy reach of children as they may cause serious
injury. The packaging materials are recyclable. .
The appliance should be installed and all the electrical connections made
by a qualified
technician
in compliance with local regulations in force and
following the manufacturers instructions. .
Do not attempt to modify the technical properties of the appliance, as it may
become dangerous to use.
Note: Appearance of your
cooktop
may be different than the model shown above
due to production changes.
1
DESCRIPTION OF THE
COOKTOP
SINGLE ZONE
HEATER
OVAL ZONE
HEATER
HOB
FRAME
VITROCERAMIC
SURFACE
TOUCH CONTROL
PANEL
READ THESE INSTRUCTIONS CAREFULLY AND COMPLETELY BEFORE USING YOUR
APPLIANCE, AND KEEP IT IN A CONVENIENT PLACE FOR REFERENCE WHEN NECESSARY.
THIS MANUAL IS PREPARED FOR MULTIPLE SIMILAR . YOUR APPLIANCE MAY
NOT HAVE SOME OF THE FEATURES THAT ARE EXPLAINED IN THIS MANUAL. REFER TO THE
MODEL A'S THAT HAVE FIGURES, WHILE YOU ARE READING THE OPERATING MANUAL.
General Safety Warnings
- This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction
concerning use of the appliance in a safe way
and understand the hazards involved. Children
shall not play with the appliance. Cleaning and
user maintenance shall not be done by children
without supervision.
- WARNING: The appliance and its accessible
parts become hot during use. Care should be
taken to avoid touching heating elements.
Children less than 8 years of age shall be kept
away unless continuously supervised.
- WARNING: Unattended cooking on a cooktop
with fat or oil can be dangerous and may result
in fire. NEVER try to extinguish a fire with water,
but switch off the appliance and then cover
flame e.g. with a lid or a fire blanket.
- WARNING: Danger of fire: do not store items
on the cooking surfaces.
COOKTOPS
1
2
SAFETY WARNINGS
- WARNING: If the surface is cracked, switch off
the appliance to avoid the possibility of electric
shock.
- For cooktops incorporating a lid, any spillage
should be removed from the lid before opening.
And also the cooktop surface should be allowed
to cool before closing the lid.
- The appliance is not intended to be operated
by means of an external timer or separate
remote-control system.
- Do not use harsh abrasive cleaners or sharp
metal scrapers to clean the oven door glass and
other surface since they can scratch the surface,
which may result in shattering of the glass or
damage to the surface.
- Do not use steam cleaners for cleaning the
appliance.
- Your appliance is produced in accordance with all applicable local and international standards and
regulations.
- Maintenance and repair work must be made only by authorized service technicians. Installation and
repair work that is carried out by unauthorized technicians may endanger you. It is dangerous to alter or
modify the specifications of the appliance in any way.
- Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure or
electricity voltage and frequency) and the requirements of the appliance are compatible. The
requirements for this appliance are stated on the label.
- CAUTION: This appliance is designed only for cooking food and is intended for indoor domestic
household use only and should not be used for any other purpose or in any other application, such as
for non-domestic use or in a commercial environment or room heating.
- All possible security measures have been taken to ensure your safety. Since the glass may break, you
should be careful while cleaning to avoid scratching. Avoid hitting or knocking on the glass with
accessories.
- Ensure that the supply cord is not wedged during the installation. If the supply cord is damaged, it
must be replaced by the manufacturer, its service agent or similarly qualified persons in order to prevent
a hazard.
2
Installation Warnings
- Do not operate the appliance before it is fully installed.
- The appliance must be installed by an authorized technician and put into use. The producer is not
responsible for any damage that might be caused by defective placement and installation by
unauthorized people.
- When you unpack the appliance, make sure that it is not damaged during transportation. In case of
any defect; do not use the appliance and contact a qualified service agent immediately. As the
materials used for packaging (nylon, staplers, styrofoam...etc) may cause harmful effects to children,
they should be collected and removed immediately.
- Protect your appliance against atmospheric effects. Do not expose it to effects such as sun, rain,
snow etc.
- The surrounding materials of the appliance (cabinet) must be able to withstand a temperature of min
100°C.
During usage
- Do not put flammable or combustible materials, in or near the appliance when it is operating.
- Do not leave the cooktop while cooking with solid or liquid oils. They may catch fire on condition of
extreme heating. Never pour water on to flames that are caused by oil. Cover the saucepan or frypan
with its cover in order to choke the flame that has occured in this case and turn the cooktop off.
- Always position pans over the centre of the cooking zone, and turn the handles to a safe position so
they cannot be knocked or accidentally.
- If you will not use the appliance for a long time, switch it off at the main controls.
- Make sure the appliance control knobs are always in the "0" (stop) position when it is not used.
During cleaning and maintenance
- Always turn the appliance off at the main control before operations such as cleaning or maintenance.
TO MAINTAIN THE EFFICIENCY AND SAFETY OF YOUR APPLIANCE, WE RECOMMEND YOU
ALWAYS USE ORIGINAL SPARE PARTS AND TO CALL ONLY OUR AUTHORIZED SERVICE
AGENTS IN CASE OF NEED.
EURO PARTS:1800.678.8352
3
· Prior to installation, ensure that the local distribution conditions and the
adjustment of the appliance are compatible.
· The laws, ordinances, directives and standards in force in the country of
use are to be followed (safety regulations, proper recycling in accordance
with the regulations, etc.)
After removing the packaging material from the appliance and its accessories,
ensure that the hob is not damaged. If you suspect any damage, do not use
the appliance, contact an authorised service personal or a qualified electrician
immediately.
· This built-in hob is to be inserted into a cut out in a
counter.
It will be
electrically connected with the switch box below counter level, especially
provided for this purpose.
· Cut an opening with the dimensions shown in the picture below.
INSTALLATION3
4
N e ig hb o o rh o od w al ls A [m m ] B [ m m ]
C o m b us ti bl e 6 0 1 50
N o n- c om b u s tib le 2 5 4 0
The electrical connection of this cooktop should be carried out by an
authorised service technician or a qualified electrician, according to the
instructions in this guide and in compliance with the current regulations.
Installing your built-in cooktop
· Screw the 4 worktop mounting brackets on the side walls of product.
· Apply the one-sided self-adhesive sealing tape supplied all the way round
the lower edge of the cooking surface along the outer edge of the glass
ceramic panel. Do not stretch it.
5
worktop mounting bracket
Electrical connection of your cooktop
ELECTRICAL CONNECTION4
6
EURO PARTS:1800.678.8352
Mode Descriptions
The appliance is operated by touching buttons and the functions are
confirmed by displays and acoustic signals.
NOTE: See the section on
COOKTOP
O RESET if you see a flashing H in any
of
the displays.
Stand-By-Mode S-Mode
The mains are applied to the cooktop
cooktop
control
and all zone
zone
displays are off or a residual
heat display is active.
Operating-Mode
B-Mode
At least one display shows a heat
setting between ´0`and ´9`
Lock Mode
VR-Mode
The control is locked.
USAGE5
7
Turning the appliance on / off . .
If the appliance is in Stand-By-Mode, it is put in Operating-Mode by pressing
the On/Off button for at least 1 second. A beep indicates a
successful
operation.
On all zones a ´0` appears and all Decimal Point of the zones flashes.
If there is no operation within 10 sec, the display of all heaters will turn off.
If the displ a y s ar e t ur n e d o ff , t h e zones will be set to off.
If is pressed more than 2 sec (in Operating-Mode), the appliance is
switched off and is set into the off mode again. The appliance can be turned
off by pressing at any time; even if other buttons are pressed
simultaneously..............................................................................
If there is residual heat remaining, this will be indicated by a flashing H in
the corresponding zone Display.
Select Zone
If a single zone is chosen with the corresponding Active/Deactive zone
Button , the Decimal Point of the related Heater Display flashes. For the
selected
zone
, you can set the heat level between 1-9 by touching the
Heat Setting Buttons or . .
The buttons must be pressed within 3 sec, otherwise the zone selection
is erased and heat setting dot will disappear (Decimal Point). If there is no
further operation within 10 sec, the zone falls back into off mode.
The heat setting can always be changed by pressing or between
level 1-9. .
Each button operation or each display change is accompanied by a beep.
8
Set Cooking Level With and Without Heat Boost .
Al l h ea te rs ar e e q u ip pe d w it h h e a t b o o s t f un ct io n a l i t y.
If the heat boost is active, then the zone will be operated with maximum
power for the period of the heat boost time, which is dependent on the
selected heat setting. This is indicated by a flashing ´A`, alternating with the
heat setting value (e.g. ´A` and then ´9`) in the heater display. Once the
heat boost time has ended, only the heat setting will be displayed.
If you want to use heat boost level 9 must be selected by pressing starting
from level 0. After setting the heat to level 9 , ´A`and the heat setting will
be displayed alternately. This means that level 9 and heat boost is active.
Co ntinue t o press the butto n to set a lo w er heat settin g.
The heat boost can be turned off by pressing until heat setting ´0` is
selected.
If the heat boost should be used, it can always be activated by actuating
again if the heat setting is set to level 9. In the heat display ´A/9` flashes.
Turn Off Individual Zones
A selective heater can be turned off in two ways:
. Simultaneous operation of and buttons
· Reduction of the heat setting to ´0` by operating button
Simultaneous operation of and buttons
The corresponding heater must be chosen with one of the Active/Deactive
Zone Button , the Decimal Point of the selected Heater Display flashes.
To turn off the zone , and must be pressed at the same time. A beep
signal sounds and ´0` appears in the heat setting display.
If there is a residual heat for this zone remaining, this will be indicated by
a static display ´H` in the heat setting display.
Reduction of the heat setting to ´0` by operating button
9
Key Loc k .
Key lock functionality is for blocking and set the appliance into a save
mode during operation. Touch modifications, for example increasing
and others should not be possible. It is only possible to switch the
heat appliance off. .
To lock the current operating mode, press the Key Lock button for at
least 2 seconds. This operation is acknowledged by a beep. The Key Lock
Indicator flashes and the controls are locked. .
The zone can only be locked in Operating Mode.
If the zone is locked, only can be operated, all other buttons are
disabled. Only the On-Off switch will operate. If you switch off the
appliance, you must switch it on again and press the lock button to unlock
the appliance before you can use it. .
.
After pressing 2 sec , the Key Lock Indicator disappears. Now, the
cooktop
control is unlocked and can be operated normally.
The heater can also be turned off by reducing the heat setting to ´0`.
When zone Display indicates ´0`, the Decimal Point of the selected zone
will also turn off.
If there is a residual heat for this zone remaining, this will be indicated by
a static display ´H` in the heat setting display.
10
Child Lock
Child lock functionality is a multiple step process.
Child locking and unlocking is only available in the S-Mode. (stand by)
First has to be pressed until the buzzer beeps, then the and have
to be pressed for at least 0,5 sec, but max 1 sec. simultaneously. Following
´L` is shown as a confirmation.
If the minute minder is still running, it will proceed until ´00` is
appliance is fully locked. None of the buttons can be used as long as the
appliance is locked.
pressing until the beep, then the and have to be pressed
a confirmation for successful unlocking, ´L` symbol in the displays will be
erased immediately.
11
zone
be
Loading...