Porter-Cable CMS200, 892321-8910 User Manual
Specifications and Main Features
- Model: CMS200
- Type of Tool: Cordless Powered Stapler
- This Tool Accepts: Medium crown (15/16" W); 16 gauge wire staples
- Size of Staples Accepted: 1” – 2” in length
- Firing Range: Fast burst of twice fasteners every second
- Limit for Continuous Use: Should not exceed 200 fasteners in fifteen minutes or 500 fasteners in an hour.
- Ambient Temperature Range: 20 degrees Fahrenheit to 120 degrees Fahrenheit
- Power Source: Portable internal combustion engine with approved porter-cable fuel cells.
- One Fuel Cell Capacity: Approximately 3000 fastening for one cell.
- Routine Maintenance: None considered, oil free, and no lubrication.
Frequently Asked Questions
Q. I would like to know what type of staples can be fitted to the CMS200?
A. CMS200 is suitable for medium crown (15/16” W) 16 ga. wire staples of varying lengths pendant from 1” to 2” long.
Q. How can I tell my fuel cell has run out?
A. The fuel cell until shaking has little energy to fire fasteners to provide sufficient energy will make a sloshing sound.
Q. Can I use any other fuel cell to the tool CMS200?
A. Only approved porter-cable fuel cells can be used in conjunction with the CMS200’S.
Q: What if the tool does not shoot out a fastener?
A: Ensure that the tool is firing fasteners properly, the perishables are topped off, and that the tool is sufficiency pressed against the work surface with sufficient pressure.
Q: Would you recommend me to clean the tool? If yes, how often should I?
A: Yes, cleaning should be performed regularly to keep the tool in a working condition. Specific attention should be directed to the fastener guide part of the tool in order to prevent fasteners from jamming.
Q: What about the air filter, is there any requirement to maintain it?
A: Yes, covering foam air filters have to be replaced inconsistently, which is dependent on the working conditions. It is advised that they be replaced at least as frequently as with the igniter.
Q: What would happen if I were to work with the tool while the temperature is below −6.67 °C (20 °F)?
A: If the tool is operated in extreme cold, for example under −6.67 °C the tool would operate intermittently or not operate at all, on top of that the fuel cells cannot operate as normal as they lack sufficient vapor pressure.
Q: Are there any special instructions regarding safety while using the CMS200?
A: Yes, always wear safety equipment such as goggles and ear protection, also ensure to keep the finger off the trigger while not firing fasteners.
User Manual
Loading...