Porta Phone ETM1900 Users Manual

Full Deplex Communication System

user manual

Introduction

Thank you for your choice of XTreme Communication System.
XTreme is a DECT (Digital Enhanced Cordless Telecommunications) Full Deplex Communication System. To
the quality of audio and to the safety offered from the digital technology, XTreme offers manifold and useful
features including Full duplex system, LED In use illumination, multi-headset capabilities and multi-volume select.
Please read this instruction carefully before using your new XTreme for the first time.

A glance guide for the headset

MicMute/CH

A glance guide for the base unit

Vol down

Mic

Receiver

Vol up

Talk/ Power on/off

All Conference

A channel indicator (GREEN LED)

B channel indicator (RED LED)

Connector for Cord Headset

Page 1

Installation

Please check your package that included the following items:

-Base Unit (Flx2000/PRO2000)

-Wireless Headset (XTreme)

-AC / DC adaptor for Base Unit

- Base packing batterie

- Headset packing batterie

Choose a suitable site for the base unit, make sure it is not near to other electrical equipments.

Connect the AC adaptor socket to the Base Unit and to your room’s power socket.

Turn on the power of base.

Fitting the battery in the headset:

The pack rechargeable batteries come with your

-Insert the rechargeable battery into the headset as the above figure indicated, matching correct polarity.

-Fit the battery compartment cover by sliding it down so that it clicks firmly into place.

NOTE: Reversing the orientation may damage the headset. Please use the battery type supplied or recommended equivalents. A

different battery could cause an explosion or damage of your headset.

Power on/off

Charging indicator

And low battery indicator

AC Adapter socket

6.0v-7.5v battery pack

3.7v battery pack

charger.

Low battery indicator

Whenever you see the low battery indicator LED flash on the headset, or you have heard the low battery warning
tone during a call conversation, please:

-End the call as soon as possible.

-Change the headset battery.
To charge the battery, put the battery into the charger cradle. The charging LED on charger unit will come on to
indicated that the battery is in charging.

Basic Functions

Page 2