Porcher 80800-00, 80810-00 Assembly And Installation Instructions Manual

ASSEMBLY & INSTALLATION
INSTRUCTIONS

Porcher Solutions™ 24"

Wall Hung Cabinet 80800-00
Base/Drawer 80810-00
Floor Standing Vanity 80800-00 & 80810-00
Floor Standing Dresser 80810-00 (purchase 3 units)
Master Suite Vanity 80800-00 (purchase 2 units) and

80810-00 (purchase 3 units)

INTRODUCTION

Thank you for selecting our Porcher product. To ensure that your installation proceeds smoothly, read these instructions
carefully before you begin. Also, review the recommended tools and materials section. Carefully unpack and examine your
new plumbing fixture.

ALL INSTALLATION PROCEDURES MUST COMPLY IN STRICT ACCORDANCE WITH APPLICABLE LOCAL
PLUMBING AND BUILDING CODES

{

Tools and Materials Required

Most of the procedures require the use of
common tools and materials, which are
available from hardware and plumbing, supply
stores. It is essential that the tools and
materials be on hand before work is begun.

Plumbers' Putty or
Caulking

Saber Saw

Putty Knife

Adjustable Wrench

10'

Tape Measure

Regular Screwdriver

Drill

Roughing-in Dimensions
Wall Hung Cabinet 80800-00

24"

(610mm)

14"

(356mm)

22"

(559mm)

16-3/4"

(425mm)

OPEN
AREA

OPEN
AREA

1"
(25mm)

9-1/4"

(235mm)

Phillips Screwdriver

Level

© Porcher 2010

12"

(305mm)

BACK VIEW

NOTE: Locate supplies and “P” trap in open area.

1-3/4"
(44mm)

770103-100 Rev. D

Roughing-in Dimensions

Base/Drawer 80810-00

22"

(559mm)

10"

(254mm)

24"

(610mm)

BACK VIEW

3/4" PLYWOOD HANGING CLEAT
ATTACHED TO CABINET

3/4" PLYWOOD HANGING CLEAT
REMOVABLE FOR INSTALLATION

Roughing-in Dimensions

Floor Standing Vanity
80800-00 & 80810-00

22"

(559mm)

16-3/4"

(425mm)

10"

(254mm)

OPEN
AREA

24"

(610mm)

30-3/4"

(781mm)

NOTE: Legs must be used when
Cabinet and Base are combined to
create a Floor Standing Vanity.

Sink not shown.

4"

(102mm)

- 2 -

FINISHED FLOOR

770103-100 Rev. D

Roughing-in Dimensions

Floor Standing Dresser
80810-00 (3 Units Required)

(102mm)

22"

(559mm)

10"

(254mm)

10"

(254mm)

10"

(254mm)

4"

OPEN

AREA

24"

(610mm)

FINISHED FLOOR

34"

(679mm)

NOTE: Legs must be used when Cabinet and Base are combined to create a Floor Standing Vanity.

Sink not shown.

- 3 -

770103-100 Rev. D