Popp IP44 Plug Quick Start Manual

POPE700397

IP44 Plug

Outdoor wall plug

Quickstart Guide

Schnellstartanleitung

Smart Home

Quickstart guide

EN

Adding the IP44 Plug to the gateway

1. Plug the IP 44 Plug into a mains powered power socket.

1

2. Set the gateway into inclusion mode. Please refer to your gateways manual
for more information about inclusion mode.

3. Press the button on the IP 44 plug 3 times within 1,5 seconds.
The LED on the IP44 Plug will flash green to confirm the inlcusion.

4. The gateway will show a successful adding in the UI or App.

Removing the IP44 Plug from the gateway

1. Plug the IP 44 wall plug into a mains powered power socket.

2

2. Set the gateway into exclusion mode. Please refer to your gateways
manual for more information about exclusion mode.

3. Press the button on the IP 44 plug 3 times within 1,5 seconds.

4. The gateway will show a successful exclusion in the UI or App.

For the extended Manual and technical Specification please refer to: www.popp.eu/700397en

Support

If you encounter any problem, please use the international community at www.z-wave.info, our web­site at www.popp.eu/support or contact us by email: [e-mail]

3x