Pop Sonic ZIP User Manual

Hello! Thanks for purchasing this Authentic Pop Sonic product. For questions

7.8.6.5.4.3.2.

1.

2.

1.

7.

6.5.4.

3.

2.

1.

4.3.2.

1.

4.3.2.

1.2.1.

about your product please call Pop Sonic customer services at [phone]
or email [e-mail].

Product features

Foil Cover

On/O

Foil Head

Switch

Getting Started

If you are a rst time electric shaver user, please keep in mind there will be
about a 2 week adjustment while your skin adapts to the way an electric
shaver functions.

Before using, charge your shaver for about 2 hours or until the charging
light turns o.

Once fully charged, your shaver should last for around 60 minutes of
shaving time.

When fully charged, disconnect shaver from charging cord and store
charging cord in a dry, safe place .

For instructions on shaving techniques, please see “Shaving Techniques”
section of this manual.

Using your Shaver

Disconnect shaver from charging cord.

Although this shaver can shave either wet or dry skin, it is our recommendation
that you clean and dry your skin before using. However, if you nd it more
comfortable or eective to use when your skin is wet, that is ne, too.

Push the on/o switch upward to turn on. Hold the shaver at a 90 degree angle to
your skin and start shaving by gently applying the foil to your skin.

For best results, hold the shaver to both foils are in contact with your skin.
However, when shaving the upper part of your lip or neck, it may be more eective
to use just the top foil.

Shave both with and against the grain of your whiskers. With your free hand,
stretch your skin taut in the path of the shaver.

Z I P

Where Style Meets Function

Cleaning and Maintenance

For best results, it is recommended that you clean your shaver after a few shaves.

Shaver can be used with shaving gels or creams but special care needs to be used if this
is the case. It is recommended that you rinse your shaver with warm water after every
use if using gel or cream.

To continue cleaning, turn o shaver and
unplug. Remove foil head by pressing the
release buttons on the side of the shaver
and lifting o the foil head.

Lightly tap the side of the foil head on a
hard surface such as your sink to remove a
majority of the stubble. Be careful not to
tap the foil, only tap the harder plastic
surrounding the foil. You can also use the
small brush that was included with your
shaver.

After that, rinse your foil to remove remaining stubble.

Before replacing foil, you may rinse your shaver blades and surrounding areas with
water as well.

Ergonomic

Grip

Charging

Port

Travel Pouch

WARNING Cutter bars are very sharp and if handled improperly
they could injure you.

To replace cutter bars, push them gently back on to the cutter bar posts. Then replace

the foil head by snapping it back into place.

Replacing cutter bars is recommended every 1-2 years, depending on the density of

your beard and the frequency with which you use your shaver. If you notice that it is

taking you longer to shaver or if you start to notice more skin irritation than before, new

cutter bars may be in order. Order directly from our website at www.ShopPopSonic.com.

FAQs

Can I use clipper oil on my blades?

YES you can use clipper oil to help maintain your blades, but it is not

A.

necessary.

When nished shaving, replace protective cover and store in a dry safe
place.

Foils are meant to be replaced every 12 months. However, if foil gets
damaged, you should replace it immediately to prevent damage to your
skin.

Be sure to take good care of your shaver by cleaning the exterior, the cutter
bars (these are under the foil), and foil about every 3-4 shaves.

Charging your Shaver

Remove the rubber cap on the bottom of the shaver then plug small end of
cord into charging port. Plug the other end into a USB port on a USB
charging plug, then plug that into a wall socket.

Charge your shaver as you notice it losing power or running a bit slower. The
charging LED light will light up while charging and will turn o when
charging is complete.

WARNINGS!

Keep away from water while plugged in. Do not attempt to retrieve shaver if it falls in
to water while plugged in. First, unplug from wall outlet, then retrieve shaver.

Always unplug shaver before cleaning.

Do not set shaver or store shaver where it can fall into water or other liquid.

It is not recommended that children under 13 use this shaver unless properly
supervised by an adult.

Do not operate shaver if the cord or plug has been damaged. Make sure to replace
damaged materials before reusing.

Do not use the shaver if the foils are damaged. This could result in injury so replace
your damaged foils before attempting to use again.

Remember to switch shaver to o position and unplug before storing or doing
maintenance on the shaver.

Use only the parts that came with your shaver, using unauthorized parts could result
in your warranty being voided.

Lithium Battery Replacement, Disposal, and Recycling

Guide the shaver gently back and forth, primarily against the grain of your beard.

NOTE! Donotpressthe foils toohard againstyour skin because this could cause skin irritation
and could also damage thefoils of your shaver.

When nished, always put the protective foil cover back on the shaver and store in
a dry, safe place.

Warranty

POP SONIC warrants the ZIP for a period of 1 year after the original date of
purchase, against defects due to faulty workmanship or materials. For
warranty claims, you must register your device and log in to your account at
www.shoppopsonic.com, then select the option to make a warranty claim.
Our customer ser vice department will then contact you to initiate the
warranty procedure.

This warranty covers working parts. It does not cover damage due to normal
usage or accidents such as dropping the device.

Other exclusions include misuse or neglect to the device. This warranty is
void if any other charging cables besides the one you received is used with
your device.

For any warranty claims, proof of purchase must be provided. For this reason,
please keep your receipt for the duration of the warranty period.

Shipping costs are non-refundable.

Specications

NOTE on the Cutter Bars (blades): Although it is not recommended, if you want

to remove cutter bars to clean more thoroughly, here is what you do

Turn o shaver

Remove foil

Grasp the ends of the cutter
bar (do not grasp cutter bar
blades)

Pull up to remove cutter bars

DO NOT oil anything other than cutter blades. All gearing and motors are

B.

permanently lubricated and do not require oil.

Over-oiling can result in oil getting into the gearing, which could cause

C.

permanent damage to your shaver.

Can I get my shaver wet?

Your shaver is water resistant but not completely waterproof. You can use it in

A.

the shower but it should not be submerged in water for any length of time.

Do not attempt to remove lithium ion battery.These types of batteries carry
inherent dangers if mishandled and can explode, catch re, or cause burns if
disassembled or are damaged in any way.

Lithium batteries are subject to local disposal regulations and should not be
discarded in regular trash. Check your local laws are regulations for disposal
information.

Lithium batteries can be recycled. For recycling information, contact your
government recycling agency, wasted disposal service, or visit online recycling
resources such as www.batteryrecycling.com or www.rbrc.com.

Power system:

Battery type:

Output:

Charging time:

Using time:

Waterproof:

Cordless rechargeable lithium ion
battery

Lithium Ion 350 mAh

DC: 5V

2 hours

45-60 minutes

IPX4