
INSTALLATION INSTRUCTIONS FOR PART 95-3528
APPLICATIONS
PONTIAC GTO
2004-2006
95-3528
KIT FEATURES
• Double DIN Radio Provision
• Stacked ISO Mount Units Provision
KIT COMPONENTS
A) Double DIN Brackets • B) Double DIN Trim plate
A
TOOLS REQUIRED:
Small Flat Blade Screwdriver • Panel Removal Tool
• 86-3528 Radio Removal Keys
1-800-221-0932
© COPYRIGHT 2008 METRA ELECTRONICS CORPORA
www.metr
B
aonline.com
TION

95-3528
TABLE OF CONTENTS
Dash Disassembly
- Pontiac GTO 2004-2006 .........................................1,2
Kit Assembly
- Double DIN Radio Provision................... ....................3
- Stacked ISO Mount Units Provision . . . . . . . . . . . . . . .. . . . . . . . . . . . . . . . . . 4
Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Final
*Note:
Refer also to the instructions included with the aftermarket radio.
5

95-3528 DASH DISASSEMBLY
PONTIAC GTO 2004-2006
Disconnect the negative battery ter-
1
minal to prevent an accidental short
circuit.
Using the radio removal keys, pull the
2
factory radio from the dash and disconnect the wiring.
3
Unsnap and remove the trim panel at
the top center of the dash above the
A/C vents and remove (4) Phillips
screws.
(Figure B)
(Figure A)
A
Remove (1) Phillips screw from inside
4
lower open storage area where
center console and dash meet.
(Figure C)
5
Unsnap and remove center console
(open center armrest/ storage compartment and work forward).
Continue on page 2.
D
(Figure D)
B
C
1

95-3528 DASH DISASSEMBLY
PONTIAC GTO 2004-2006
Remove (2) Phillips screws exposed
6
at the bottom of the center panel surrounding radio and remove panel.
(Figure E)
Unclip and remove trim panel sur-
7
rounding radio and A/C controls.
8
Remove (3) Phillips screws holding
"cage" in radio opening.
Pull down on the "cage" from the
9
opening inside on the top and
remove.
Continue to final assembly.
(Figure G)
(Figure F)
E
F
2
G

95-3528 KIT ASSEMBLY
DOUBLE DIN RADIO PROVISION
*Note: Refer also to the instructions included with the aftermarket radio.
A
Attach the Double DIN brackets to the
1
Double DIN radio unit using the screws
supplied with the radio.
Continue to final assembly.
(Figure A)
3

95-3528 KIT ASSEMBLY
STACKED ISO MOUNT UNITS PROVISION
*Note: Refer also to the instructions included with the aftermarket radio.
A
Attach the Double DIN brackets to the
1
stacked ISO mount units using the
screws supplied with the units.
(Figure A)
Continue to final assembly.
4

95-3528 FINAL ASSEMBLY
FINAL ASSEMBLY
A
B
C
D
Locate the factory wiring harness in the dash. Metra recommends using the
1
proper mating adapter and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.)
Re-connect the negative battery terminal and test the unit for proper operation.
2
Insert and secure the radio/bracket assembly into the radio opening using the
3
screws removed in step 8 of disassembly.
Snap the Double DIN trim plate onto the bracket/radio assembly.
4
Reassemble in reverse order of disassembly.
5
(A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown below and the instructions included with the
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and
individually tape off ends of any unused wires to prevent electrical short circuit.
METRA / EIA WIRING CODE
12V Ignition / Acc . . . . . . . . . . Red
12V Batt / Memory. . . . . . . . . Yellow
Ground. . . . . . . . . . . . . . . . . . Black*
Power Antenna. . . . . . . . . . . . Blue
Amp Turn-On . . . . . . . . . . . . . Blue / White
Amp Ground. . . . . . . . . . . . . . Black / White
Illumination . . . . . . . . . . . . . . Orange
White
Dimmer . . . . . . . . . . . . . . . . .
Orange /
Right Front (+) . . . . . . . . . . . . Gray
Right Front (-). . . . . . . . . . . . . Gray/ Black
Left Front (+) . . . . . . . . . . . . . White
Left Front (-). . . . . . . . . . . . . . White / Black
Right Rear (+) . . . . . . . . . . . . Violet
Right Rear (-) . . . . . . . . . . . . . Violet / Black
Left Rear (+) . . . . . . . . . . . . . Green
Left Rear (-)
. . . . . . . . . . . . . .
Green / Black
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’s specifications.
5

95-3528 INSTRUCTIONS
1-800-221-0932
REV. 05/07/08 © COPYRIGHT 2008 METRA ELECTRONICS CORPORATION INST95-3528
www.metraonline.com