Polycom Webcam User Manual

Setting up the Polycom PowerCam Presenter

What's in the boxes? Setting up the Controller

Note: If you are connecting an optional Polycom® VSX™ video conferencing system to your Polycom PowerCam Presenter™, see the other side of this document.

Male RCA to female
S-video adapter

10’ or 100’ camera cable

Camera power cables

1

IOIOIO

Menu

Select

Zoom In

Preset 1

Auto Zoom

Preset 2

Zoom Out

Presenter View

Tight

Wide Off

Right

Left

VCR/DVD

VCR or DVD recorder

Video output from
connector shows
Presenter icons and
messages

21

1

2

8’ S-video cable 25’ S-video cable

A/C power cable

90-250VAC 50/60Hz 4A

LAN

LAN cable

Use only for
upgrading
software

Display

Display

Any video conferencing system

Setting up the Locator Pack Assembly

1

Caution

Refer to the User’s Guide for the Polycom PowerCam Presenter for important
information about charging and using the battery pack.

2

Operating time: 8 hours

3

4

b

Attach the belt clip to the locator pack OR attach the lanyard to the locator pack.

Charging time: 3 hours

Setting up the Controller with a VSX Video Conferencing System

S-video gender
changer adapter

10’ or 100’ camera cable

10’ or 100’ camera cable

Powering on the Polycom PowerCam Presenter

After all the cables are connected, power on the Polycom

1

PowerCam Presenter controller:

IR

3

1

VCR/DVD

IOIOIO

1

2

PC CARD

1

2

VGA

2

VGA

VSX video conferencing system

PowerCam Presenter Controller

Camera
adapter
cable

90-250VAC 50/60Hz 4A

LAN

1

IOIOIO

21

Video output from

1

25’ S-video cable

2

Male RCA to
female S-video
adapter

LAN

90-250VAC 50/60Hz 4A

Camera power cables

If you have a VSX video conferencing system, power it on next:

2

Wait 90 seconds, and then power on the locator pack:

3

connector shows

Display

Presenter icons and
messages

8’ S-video cable

LAN cable

Use only for
upgrading
software

A/C power cable

Setting up the Camera

1

1725-23626-001/A

2

3

4

Place the camera where it will be no more than
50 feet (15.2 meters) away from the person
wearing the locator.

Place the camera about 6 feet (1.8 meters) to
7 feet (2.1 meters) above the floor.

Leave at least 1 foot (.3 meters) between the
back of the camera and the wall. If you add
acoustic foam on the wall, you can place the
camera slightly closer than 1 foot (.3 meters)
from the wall.

©2006, Polycom, Inc. All rights reserved. Polycom® and the Polycom logo are registered trademarks, and Polycom PowerCam Presenter™ and VSX™ are trademarks of Polycom, Inc.