Polycom KIRK IP User Manual

Polycom® KIRK IP Interface Card - User Guide

1. Introduction

This guide helps you setting up the KIRK Wireless Server 1500 with IP Interface Card on a Cisco CallManager.
Please refer to your CallManager user manual for general information.

2. Installation

1. Power down the WMS (Wireless Mobility Server).

2. Remove the top cover by unscrewing the screws on both sides of the WMS and the screws at the rear panel.

3. Remove the blind cover plate in front of the slot

closest to the power supply (please refer to the
figure at right).

4. Insert the KIRK IP Interface Card into the slot 0

(see drawing) and mount the two screws from the
blind cover.

5. Put back the top cover.

6. Connect an RJ45 cable (not included) between the

KIRK IP Interface Card on the back of the WMS
and the LAN network.

7. Power up the WMS again.

8. Verify that the LED’s are flashing as follows:

Active

In HTTP mode and when packets are transmitted on the Ethernet the Active LED is turned on.

100

In HTTP mode and when the Ethernet speed is 100mbps the 100 LED is turned on. When 10mbps Ethernet is
connected it will be off. ‘

Link

When the Ethernet link layer is established the Link LED is turned on.

Ready

When the system is running and ready the Ready LED is turned on. If the system is not ready the LED will start
flashing. In TFTP mode the Ready LED is flashing and all other LED’s are off.

Front LED

The front LED is green when the system is running and the subscriptions are read

.

Software and help files are available at: http://www.kirktelecom.com/Installers/suk227.asp

3. IP Addresses

The KIRK IP Interface Card is configured with the IP address: 192.168.0.1 as a standard. This address has to be
changed for customizing the sub-net mask of the network. Start configuring the PC to the IP system’s identical net
mask, e.g. the address: 192.168.0.2 and sub-net mask: 255.255.255.0. The system is now ready to be reached with a
standard internet browser.
To change the address in the card to e.g. 10.1.1.150 please follow the steps below:

1. Start an Internet browser and address the card with IP

address 192.168.0.1

2. Select Gateway -> Config (user = admin, password =

ip1500)

3. Select IP Interfaces -> Ethernet Interface in the pop up

window

4. It is now possible to change the IP address of the card

and the IP address mask. Type the new IP address in
the ”IP address” field and press save -> activate.

5. Type the default router if applicable

6. No other fields are supported

7. Select IP Interfaces

8. Type off service must be set to 0xb8, and press save ->

activate.

4. Configuring the KIRK IP Interface Card to the
CallManager

1. Start an internet browser and address the card

2. Select Gateway -> Config (user = admin, password =

ip1500)

3. Select DECT Interface -> GW-DECT

4. Set protocol to “Skinny”

5. Type the IP address of the Gatekeeper. (Primary Call

Manager IP)

6. Type the IP address of the alternate Gatekeeper.

(Secondary Call Manager IP)

7. Type DECT1 in HW ID

8. Check the “enable user directory” box

9. Press Save -> Activate

10. No other fields are supported.