9
2
12
13
3
4
5
10
6
7
8
11
15
14
1
16
17
ENGLISH Espresso 2000
1) Mains ON/OFF Switch
2) “ON” Indicator Light-Machine Switched On
3) “Out Of Water” Indicator Light
4) Coffee Dispenser Button
5) Steam Preparation Button
6) Steam Dispenser Handle
7) Steam Dispenser
8) Water Heating Chamber
9) Top Cover
10) Water Reservoir
11) Drip-Tray
12) Coffee Compress
13) Power Supply Cable
14) Filter Holder For Ground Coffee
15) Filter For One Portion
16) Filter For Two Cups
17) Holder for Coffee Bags
Polti S.p.A. reserves the right to change equipment
or accessory specification without prior notice.
Espresso 2000 ENGLISH
Dear Customer,
Thank you for choosing this quality Polti product. ESPRESSO 2000 is one of the
“Aroma” range, a new type of expresso machine which guarantees the very best aroma
and taste.
ESPRESSO 2000 has been conceived and manufactured with the very best components,
to ensure top quality and absolute safety in use.
The technical features and high-quality materials used in production makes ESPRESSO
2000 the machine which will give you years of trouble free usage.
Before first using ESPRESSO 2000 , please read carefully the operating instructions.
SSSSAAAAFFFFEEEETTTTYYYY FFFFIIIIRRRRSSSSTTTT!!
• Before using ESPRESSO 2000, please read the operating instructions carefully.
• Before connecting the appliance, ensure that the power supply corresponds to that of
the machine and that an earthed plug is fitted.
• Do not touch the appliance with wet hands or wet objects whilst the appliance is
connected to the mains, and do not put the appliance itself in water.
• Do not allow your ESPRESSO 2000 to be used by children or anyone not familiar with
the operating instructions.
• Empty the drip-tray periodically to avoid overflows.
• Never leave the appliance unattended with the cable plugged into the mains.
• If the ESPRESSO 2000 is left unused, always disconnect it from the mains.
• Do not lay the hot appliance on surfaces sensitive to heat.
• In case of breakdown or malfunction switch off the appliance and never attempt to disas-
semble it, but refer to an authorized service center.
• Never direct the jet of steam towards people, animals or small particles of debris without
first protecting the user’s eyes.
IIIIMMMMPPPPOOOORRRRTTTTAAAANNNNTT
• In the case of machine breakdown or malfunction, do not attempt to repair the machine
but contact your nearest Polti Service Centre.
• If you need to replace the power supply cable contact only a POLTI Authorised Service
Centre or qualified electrician.
Polti S.p.A. and its agents cannot be responsible for consequences of usage which
is not in accordance with these operating instructions.
!!
TT
ENGLISH Espresso 2000
PPPPRRRREEEEPPPPAAAARRRRAAAATTTTIIIIOOOONNNN FFFFOOOORRRR UUUUSSSSEE
EE
1) Remove the top cover (9) and fill the water container
(10) taking care not to overfill above its 1.3 litre
capacity.
2) Switch on the general ON/OFF switch (1) on the side of
the appliance (fig. 3).
Check that the indicator lights on (2) and coffee
dispensing light (4) have lit up.
When the coffee dispensing indicator light (4) goes out
ESPRESSO 2000 is ready to dispense coffee. This
indicator light subsequently goes on and off from time
to time, indicating that the appliance is maintaining water
at constant temperature. This is an entirely normal
function.
Before first use, or when the machine has not been
used for some time, we recommend that the water
container (10) should be emptied and washed out. Then
commence a full operation so as to clean out the entire
system (do not drink the coffee from this operation).
We recommend the use of a coffee bag or ground
coffee in this operation. This will guarantee the
wonderful aroma of your subsequent cups of coffee.
Fig. 1
Fig. 2
Fig. 3
PPPPRRRREEEEPPPPAAAARRRRAAAATTTTIIIIOOOONNNN OOOOFFFF GGGGRRRROOOOUUUUNNNNDDDD CCCCOOOOFFFFFFFFEEEEEE
EE
1a) Insert the required filter for the number of cups (1 or 2)
in the filter holder (14), and fill it with the desired quantity
of ground coffee.
2a) Compress the coffee powder in the filter holder against
the compress (12) (fig. 3).
3a) Insert the filter holder under the water heating chamber
(8) and fix it there by rotating it from left to right until it
locks on (fig. 6).
4a) Locate a cup exactly under the filter holder, or 2 cups
one on the right and one on the left, corresponding with
the holes in the filter holder (fig. 5).
Fig. 4
Fig. 5
Espresso 2000 ENGLISH
5a) Press the coffee dispenser button (4). In a few moments the coffee will start to come
through the filter holder. When you have the desired quantity of coffee, press the button (4) again to stop dispensing.
6a) Detach the filter holder by moving right to left and empty the remains of the coffee.
When not in use, we recommend you dismantle the filter holder from the machine to
avoid any risk of mis-shaping.
Note: By varying the dosage quantity of coffee and the degree of grinding with a stron-
ger or less strong pressing, you can vary the aroma of your espresso. For the
best flavour, we recommend you preheat the coffee cups, and that you use fine
porcelain cups.
PPPPRRRREEEEPPPPAAAARRRRAAAATTTTIIIIOOOONNNN UUUUSSSSIIIINNNNGGGG CCCCOOOOFFFFFFFFEEEEEEEE SSSSAAAACCCCHHHHEEEETTTTSS
As well as the usual ways of preparation, ESPRESSO 2000 can also take prepared
sachets, which guarantee the correct quantity, grinding and compression and peak flavour from its sealed hygienic sachet.
Each sachet is for a single cup of coffee, guaranteeing consistent peak quality every time.
For this purpose Polti has created the special holder for coffee sachets.
Follow the instructions as in “preparation for use”, then proceed as follows:
1b) Insert the sachet in the special filter holder for sachets
(17) (fig. 6).
2b) Insert the filter holder under the water heating chamber
(8) and rotate it left to right until it locks on.
3b) Proceed as in points 4a and 5a.
Note: While dispensing, you will experience a slight
escape of water droplets from the top part of the filter holder. This is due to a
capillary effect on the sachet bag material, and is perfectly normal.
4b) Detach the filter holder by rotating right to left and then remove the used sachet. If
the bag remains attached to the bottom of the water chamber, just operate the
machine for a few seconds and it will then be easily removed.
Note: If there is to be a little time before preparation of the next coffee, we recom-
mend you leave the filter holder fixed to the bottom of the water heating chamber so as to keep it hot and assure best results for the next cup of coffee.
Fig. 6
SS
ENGLISH Espresso 2000
PPPPRRRREEEEPPPPAAAARRRRAAAATTTTIIIIOOOONNNN OOOOFFFF CCCCAAAAPPPPPPPPUUUUCCCCCCCCIIIINNNNOO
1c) Switch on ESPRESSO 2000 as indicated in the
“preparation for use” section. When the coffee dispenser
button (4) lights up, press the steam preparation button
(5), the button will glow red.
2c) Wait for the light (4) to go out (about 30 seconds).
3c) Move the steam dispenser (7) to above the drip-tray.
Open briefly the steam dispenser handle (6) to eliminate
any remaining condensation from the tube (fig. 7).
4c) Move the steam dispenser to a position outside the machine, so that you can immerse
it in milk to a depth of about 3 cm taking care not to hold it directly to the bottom of
the container which would impede the escape of steam.
Note: For the best frothing, we recommend you use very cold, skimmed milk.
5c) At the end of the frothing close the handle again (6) and remove the dispenser from
the milk.
Important! Only remove the dispenser from the milk after you have closed the handle!
6c) Switch off the steam preparation button.
OO
Fig. 7
7c) Push the steam dispenser (7) back to its original position above the drip-tray.
8c) Press the coffee dispense button (4) until some water begins to escape from the
dispenser, so as to arrive again at the correct quantity of water in the generator.
CCCCAAAARRRREEEE!!
Before switching on the machine, make sure there is water in the container (10). Lack of
water is also signified by the indicator light (3) showing a red light.
The audible signal and indicator light are pre-set to come in to operation at the point where
there is minimal water in the tank. This is to ensure that ESPRESSO 2000 is never
completely empty of water.
!!
Espresso 2000 ENGLISH
FILLING THE TANK AFTER THE NO WATER SIGNAL
It is a fundamental principle to always switch off ESPRESSO 2000 at the general ON/OFF
switch (1) before refilling. For this reason the appliance is fitted with a safety device, which
will not allow the machine to be used if it has not been first switched off and then switched
on again. We therefore recommend you switch off immediately before refilling. After
refilling, switch the appliance on again and in a few seconds ESPRESSO 2000 will be ready
to use again.
Note: On removing the water reservoir (10), a microswitch will operate. On replacing
the reservoir after emptying, exert a gentle pressure to allow the microswitch
to ascertain the replacement of the container.
GGGGEEEENNNNEEEERRRRAAAALLLL MMMMAAAAIIIINNNNTTTTEEEENNNNAAAANNNNCCCCEEEE PPPPOOOOIIIINNNNTTTTSS
• Empty and clean out the water container (10) periodically to avoid scale deposits
inside the tank in hard water areas.
• Periodically remove the drip-tray (11) from its housing and clean out.
• During cleaning and maintenance, ensure that no water or dampness is introduced into
the coffee container.
SS
Loading...