Page 1
R
Page 2
2
EE
EE
NN
NN
GG
GG
LL
LL
II
II
SS
SS
HH
HH
CINDERELLA AS 300
EEEENNNNGGGGLLLLIIIISSSSHH
HH
KEY
1. Handle
2. Motor
3. Rotating hooks for cable storage
4. Power supply cable
5. Handle locking screw
6. Mains ON/OFF switch
7. Eyelet
8. "Full bag" red indicator light
9. Cover of bag/filter housing
10. Microfilter cover
11. Dust bag
12. Dust bag support
13. Motor filter (Fig. 9)
14. Microfilter (Fig. 11)
a) Lance
b) Universal brush
b1) Brush selector
Polti S.p.A. reserves the right to change equipment
or accessory specification without prior notice.
CCCCOOOORRRRRRRREEEECCCCTTTT UUUUSSSSEEEE OOOOFFFF TTTTHHHHIIIISSSS PPPPRRRROOOODDDDUUUUCCCCTT
TT
This appliance is intended for use as a vacuum for solids only in accordance with the
descriptions and instructions in this manual.
PPPPRRRREEEEPPPPAAAARRRRAAAATTTTIIIIOOOONNNN FFFFOOOORRRR UUUUSSSSEE
EE
1.a Before using the vacuum cleaner, assemble
the handle (1)
2.a Remove the locking screw (5) from the handle
(1) and locate it in the power plant (2) (fig. 1)
3.a Tighten the screw (5) with the wrench n. 6
supplied, turning it clockwise (fig. 2)
SSSSUUUUCCCCTTTTIIIIOOOONN
NN
The appliance is now ready to operate
1.b Connect the accessory required for the cleaning operation.
2.b Connect the supply cable to the mains and
push the mains ON/OFF switch
1
10
2
9
8 4
6
14
3
7
5
B1
B
1211
a
Page 3
MMMMAAAAIIIINNNNTTTTEEEENNNNAAAANNNNCCCCEE
EE
Before any kind of maintenance, make sure that
the supply cable is not connected to the mains.
REPLACING THE DUST BAG
1.c When the dust bag is full, the indicator light (8)
will go from green to red (fig. 5).
2.c Lay the appliance on the floor.
3.c Remove the cover (9) (fig. 6) by pushing the
opening button.
4.c Take out the dust bag support (12) by pushing
it backwards and then lift it by holding the flap
(Z), taking care not to damage it.
5.c Fold the flap (Z) on itself so as to fill the hole
and avoid dust leakage.
6.c Insert the new dust bag (11) adapting it to the
housing and keeping the flap (Z) upwards, insert the opposite side of the flap in the
grooves at the bottom of the housing, as
shown in fig. 8.
7.c Insert the sleeve in the hole of the bag.
8.c Put the cover (9) back in its position
CLEANING OR REPLACING
THE MOTOR FILTER
It is recommended to clean the filter every two times
you replace the dust bag. It is recommended to replace the filter every five times you replace the dust
bag.
1.d Lay the appliance on the floor
2.d Remove the cover of bag/filter housing (9)
3.d Take out the dust bag (11) , as described in
the "Replacing the dust bag" paragraph.
4.d Take out the motor filter (13) as shown in fig.
5.d Wash it with soap and water, rinse it and
leave it to dry well. If the filter is damaged,
replace it.
CLEANING OR REPLACING THE MICROFILTER
It is recommended to clean the filter every two times
you replace the dust bag. It is recommended to replace the filter every five times you replace the dust
bag.
1.e Lift the cover (9) which holds the microfilter
and it will unhook.
3
EE
EE
NN
NN
GG
GG
LL
LL
II
II
SS
SS
HH
HH
CINDERELLA AS 300
Fig. 5
Fig. 1
Fig. 6
Fig. 3
Fig. 2
Fig. 4
6
Fig. 6 bis Fig. 7
Z
Fig. 8 Fig. 9
13
Fig. 10 Fig. 11
Page 4
2.e Remove the microfilter (14) from its position
(fig. 11) to clean it with soap and water, rinse
it and leave it to dry.
3.e Put the filter (14) back in its correct position
and close the cover (10).
Cinderella can be hung from the eyelet (7) on
a hook, which must be capable of carrying at
least 5 kg.
UUUUSSSSEEEE OOOOFFFF TTTTHHHHEEEE UUUUNNNNIIIIVVVVEEEERRRRSSSSAAAALLLL BBBBRRRRUUUUSSSSHHHH ((((BBBB))
))
Insert the brush. If you move the selector on the
brush (B1) by pressing with your foot, you can
change the suction surface without bending down.
The position with the bristles outside is recommended for all floors. The position without bristles
is recommended for carpets and rugs.
CCCCLLLLEEEEAAAANNNNIIIINNNNGGGG TTTTHHHHIIIISSSS AAAAPPPPPPPPLLLLIIIIAAAANNNNCCCCEE
EE
Wipe the body of the appliance and the accessories with a damp cloth and then dry.
Do not use abrasive products.
PPPPRRRREEEECCCCAAAAUUUUTTTTIIIIOOOONNNNSS
SS
Attention! Do not use the appliance without
reading the instructions.
• In case of damage or malfunction, do not at-
tempt to disassemble the appliance but contact
the nearest Polti Authorised Service Centre.
• Do not allow children to use the machine or any
others who may not know how to operate it .
• Do not touch the appliance with wet hands or
feet when it is plugged into the mains.
• In order not to compromize the safety of the ap-
pliance, only use original spare parts and accessories, approved by the manufacturer.
• Do not use the appliance if the supply cable or
other important parts of the unit are damaged.
• If the supply cable is damaged, it must be re-
placed by the manufacturer or by Polti authorized Service Centre.
• Do not suck up acids or solvents, which may
cause serious damage to the appliance and es-
pecially do not suck up explosive liquids, inflammable gases, explosive powders, benzines,
paints, fuel oil, which may cause explosions if
they come in contact with the sucked up air.
• Do not use the appliance outdoor or on wet surfaces or to suck up liquids.
• Do not suck up hard or sharp objects, hot cinders or lit cigarettes or similar.
• Do not use the appliance in environments where
there is danger of explosion.
• Do not suck up objects on fire or that are hot.
• Never immerse the appliance in water.
AAAATTTTTTTTEEEENNNNTTTTIIIIOOOONN
NN
The filters and the dust bags are sold by Polti authorized Service Centres and by quality electrical
retailers. We recommend to use manufacturer's
original spare parts only.
• Polti declines liability for any damage
or accident derived from any use of
CINDERELLA AS 300 which is not in conformity with the instructions contained in
this booklet.
4
EE
EE
NN
NN
GG
GG
LL
LL
II
II
SS
SS
HH
HH
CINDERELLA AS 300
Page 5
EEEELLLLEEEECCCCTTTTRRRRIIIICCCCAAAALLLL SSSSAAAAFFFFEEEETTTTYY
YY
No earth required.
Ensure the mains voltage suits your appliance.
Fitting the mains plug important
The wires in the mains lead are coloured in accordance with the following code:
• Blue: Neutral
• Brown: Live
The wire which is coloured BLUE must be connected to the Terminal which is marked with the letter “N” or coloured BLACK.
The wire which is coloured BROWN must be connected to the Terminal which is marked with the letter “L” or coloured RED.
It is important that the outer sheath is clamped correctly into the 3-pin plug.
If in doubt consuot your local Service Dealer or
qualified electrician before the machine is used.
A 13 AMP FUSE MUST BE FITTED TO THE MAINS
PLUG.
BLACK
OR
BLUE
RED
OR
BROWN
L
E
N
F
U
S
E
5
EE
EE
NN
NN
GG
GG
LL
LL
II
II
SS
SS
HH
HH
CINDERELLA AS 300
Loading...