Polk Audio XRt112 User Manual

Owner’s

XXRRtt1122

TUNERTUNER

referencereference

Manual

1

2

3

4

5

6

7

8

9

0

display

menu

mute

preset/direct

jump

sel

ect

select

cat.

cat.

TANT SAFETY INSTRUCTIONS

entermenumemorydisplay

category

select

XM Reference Tuner

IMPOR
READ BEFORE OPERATING EQUIPMENT

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with dr

y cloth.

7. Do not block any ventilation openings. Install in accordance with the
manufacturer's instructions.

8. Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus (including amplifiers) that produce heat.

9. Do not defeat the safety purpose of the polarized or grounding-type plug. A
polarized plug has two blades with one wider than the other. A grounding type
plug has two blades and a third grounding prong. The wide blade or the third
prong are provided for your safety. If the provided plug does not fit into your
outlet, consult an electrician for replacement of the obsolete outlet.

10. Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.

11. Only use attachments/accessories specified by the manufacturer.

12. Use only with the cart, stand, tripod, bracket, or table specified by the
manufacturer, or sold with the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination to avoid injury from tip-over.

13. Unplug this apparatus during lightning storms or when unused for long periods
of time.

14. Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or
has been dropped.

WARNING: To reduce the risk of fire or electric shock, this apparatus should not

15.
be exposed to rain or moisture and objects filled with liquids, such as vases,
should not be placed on this apparatus.

o completely disconnect this equipment from the mains, disconnect the power

16. T
supply cord plug from the receptacle.

17. The mains plug of the power supply cord shall remain readily operable.

WELCOME TO THE WORLD OF XM SATELLITE RADIO

What could be better than digital quality, commercial free music played

ough your own home audio system? (That’s a rhetorical question.)

thr

Your new Polk Audio XM Reference Tuner brings the world of satellite radio
into your home, so you can enjoy XM Satellite Radio’s critically acclaimed
digital music and talk radio channels through your own home entertainment
system.

For information about other Polk Audio products, including high performance
loudspeakers that will enhance your enjoyment of XM Satellite Radio, visit
www.polkaudio.com.

For the latest programming information from XM Satellite Radio, or to activate
your XM subscription, visit www.xmradio.com.
Satellite Radio service in order to use this product. You can also
activate your service by calling 1-800-XM-RADIO (1-800-967-2346).

vice is not available in Alaska and Hawaii.

Ser

BOX CONTENTS:

Your XM Reference Tuner contains the following components:

XM Reference Tuner with built-in AC Power Cord
XM High-Gain Home Antenna
XM Remote Control, Batteries Included

Optical Cable
3-connector RCA Analog Stereo Audio/(Composite)Video Cable, 2 Meters
XM Channel Reference Card
This Owner’s Manual
Online Registration Information

If anything is missing or damaged, or if your XM Reference Tuner fails to oper­ate, notify your dealer immediately, or if your XM Reference Tuner was
shipped to you directly, notify your shipper immediately. Polk Audio recom­mends that you keep your original carton and packing materials in case you
need to ship the unit in the futur

e.

You must activate your XM

Polk Audio XM Refer

ence T

equires separate subscription and activation from XM

uner r
Satellite Radio, Inc. Go to www.xmradio.com for details. Not available in AK or HI. XM
and XM Reference Tuner are trademarks of XM Satellite Radio, Inc.

2 Contact Polk Audio Customer Ser

vice 1-800-377-7655 (Outside US: 410-358-3600)

Monday-Friday

, 9:00 AM-6:00 PM Easter

[e-mail]

ime,

n T

XM High-Gain Home Antenna

Optical Cable

eo Audio/(Composite)V

Ster

XM Reference Tuner

ideo Cable

XM Remote Control, Batteries Included

for more information visit our website at www.polkaudio.com 3

view of the Set-Up Process

Over

I. Connect the XM Reference Tuner to your home audio equipment.
II. Position the High-Gain Antenna for the best signal.
III. Activate your XM Satellite Radio subscription.

XM TUNER SET-UP

Set up your XM Reference Tuner as follows:

1. Connect your XM Reference Tuner’s audio output to your

pre-amp/receiver using either the supplied 3-connector
RCA Analog Stereo Audio/(Composite)Video Cable or a
TOSLINK Digital Audio Cable connection. You may also
use a Digital Coaxial RCA-type Cable (not included).
See Figure 1.

2. Be sure to maintain consistency by matching red-to-red

and white-to-white when connecting the RCA cable.

3. Connect the XM High-Gain Home Antenna to the jack

labeled “ANTENNA” on the rear panel of the XM Reference Tuner.

4. You may wish to connect your XM Reference Tuner to your television via the Yellow

Connector of the (supplied) 3-connector RCA Analog Stereo Audio/(Composite)Video
Cable. This will allow you to view the XM Display on your television (if you are using
Digital Audio, do not connect the Analog Audio output).

5. The Power Cord of the XM Reference Tuner must be plugged into a standard 120V home

outlet. You may also plug the Power Cord of the XM Reference Tuner into the switched AC
Outlets of your pre-amp/receiver, if available.

After powering up, if the display reads “ANTENNA,” check that the antenna connection is
secure and completely pushed in. Next, change channels (from 0 to 1, or from 1 to 0 if the
Tuner is not activated yet). If the “ANTENNA” message remains, power down the Tuner, unplug
the antenna and look for any obvious damage. If no damage is detected, reconnect the antenna,
turn the unit back on and change channels again. If the message still appears, contact your
retailer or Polk Audio Customer Service at 1-800-377-7655.

Using The Remote

1. The Remote Control included with your XM Reference Tuner does not control system

volume. The pre-amp/receiver to which you have connected your XM Reference Tuner will
control the system volume. (If the XM Reference Tuner signal is too high or too low, use the
Line Level Out menu command on Pg. 9 to adjust the audio signal level of the
XM Reference Tuner.)

2. Install the batteries (included) as shown in Figure 2.

3. If the remote control’s range begins to shorten, replace both batteries with new ones.

4. Direct sunlight or light from a high-frequency fluorescent lamp may cause the remote sensor

on the XM Refer

ence T

Refer

ence T

uner out of this dir

ect light.

ont panel to not function properly. If this happens, move the XM

uner fr

About the RS-232C Connection:

The RS-232C Connection is pr

ovided to allow the XM Refer
compatible 3rd party control systems. Polk Audio recommends that this connection only be
used by experienced pr
to a computer

. This connection IS NOT compatible with personal computers.

ofessional system installers. DO NOT connect the RS-232C Connection

uner to be contr

ence T

FIGURE 1

olled by

FIGURE 2

XM HOME ANTENNA SET UP

Aiming your XM High-Gain Home Antenna

If the XM Refer
repositioned. In addition, even if you are receiving the XM signal, it is recommended
that you optimize the position of your XM High-Gain Home Antenna as described in
this section enabling you to receive the strongest possible signal and
consistent reception.

Your XM Reference Tuner display has two different signal-strength indicators which
will help you optimize your antenna’s position.

I. Basic Signal-Strength Indicator

Your XM Reference Tuner display has a basic signal-strength indicator visible at the top
of the display screen during normal listening (Figure 3). The signal strength is indicated
by up to three vertical bars; three bars represent the strongest signal. (Zero bars represent
a weak signal.)

II. Antenna Aiming signal-strength indicator

1. A higher-resolution signal-strength indicator screen is available to allow you to optimally
aim your XM High-Gain Home Antenna. To access and use this screen:

2. Press the MENU button on the face of the XM Reference Tuner and select the “Antenna
Aiming” option. A screen similar to Figure 4 will appear.

3. Adjust the antenna location until the maximum number of “SATELLITE” bars is filled in.
Your XM Reference Tuner will receive programming as long as either the satellite or
terrestrial signal has two bars filled in; selecting a position with the maximum number
of “SATELLITE” bars displayed will ensure a consistently strong signal.

4. Press the MENU button once to return to the menu screen. Press the MENU button
again to return to the normal play screen.

Positioning The High-Gain Home Antenna

The antenna that comes with your XM Reference Tuner is a High-Gain Antenna that easily
receives the XM signal from the XM Satellites and, depending on where you live, the XM

restrial Repeater System. It is recommended that your antenna be positioned near a

er

T
South-facing window or at least a clear view of the southeaster
strongest satellite signal.

o position your antenna, first connect your XM Refer

T
described earlier. Next, position the antenna until you receive the strongest possible satellite
signal. If the satellite signal is not available, you can optimize for the ter

e available).

(wher

ence Tuner display says, “NO SIGNAL,” the antenna needs to be

n sky in or

uner to your audio system as

ence T

der to r

restrial signal

eceive the

FIGURE 3

FIGURE 4

4 Contact Polk Audio Customer Ser

vice 1-800-377-7655 (Outside US: 410-358-3600)

Monday-Friday

, 9:00 AM-6:00 PM Easter

[e-mail]

ime,

n T

for more information visit our website at www.polkaudio.com 5