Polk Audio mi Dock 10 User Manual

What’s In The Box?

miDock™10 docking system for iPod
Three Docking Cradle Adapters
12V power adapter for AC operation
Remote Control

Setting Up Your miDock™10

1. AC & Battery Operation. Plug the adapter cable into

the 12V DC power input jack located on the back of
the unit. Plug the AC power adapter into a 120V wall
outlet. To enjoy your favorite music anywhere anytime,
install eight (8) C batteries in the battery compartment
located on the back of the unit.

¤

¤

¤

¤

You can connect other music sources to your
miDock™10 auxiliary input jack using a 3.5 mm stereo
cable (not supplied).

You can connect headphones (not supplied) to your
miDock™10 headphone jack for private listening.

To keep your iPod synchronized with iTunes, you can
connect your

miDock™10 to your computer using the

USB cable supplied with your iPod.

iPod and iTunes are trademarks of Apple Computer, Inc., registered in the US and other countries.

User’s Guide

40-1493

Introduction

The miDock™10 is a portable audio system
designed specifically for iPod and other
MP3 players and can be powered by an
AC adapter or batteries. Your miDock™10
also charges the battery for your iPod
when it is docked and the AC power
adapter is plugged in. The following
information will help you get the most
from your miDock™10.

Battery Compartment

12V DC/1.5A

Apple Connector

Headphones

AUX

2. Dock Your iPod. With your miDock™10 turned off, slide the Slide Connector to the left

for iPod nano or to the standard position (right) for all other models.

Flip the flat-plate adapter to accommodate changes in depth between the Video iPods
and the other iPods that share slots in the docking cradle.

Slide the supplied adapter that matches your iPod into your

miDock™10 docking cradle.

For best sound performance, turn off the iPod EQ settings. Follow the instructions for
EQ settings that were supplied with your iPod.

Insert your iPod into the docking cradle and push down gently but firmly to ensure that
the docking connector is fully seated and your iPod is securely held in the cradle.

Caution—Listen To This!

Slots for your miDock™10 adapters are clearly marked inside the docking cradle. Use
the slot that matches your iPod to ensure a proper fit for your iPod and to prevent
connector damage.

3. Turn It Up! Your

miDock™10 turns on automatically when you insert

your iPod. To play music, press play on your iPod or remote control.

Caution—Listen To This!

Set your miDock™10 volume at a safe level before playing music.

Remote Control

Before using the remote control for the first time, pull out the plastic
tab from the battery compartment.

To replace the remote control battery (CR2025), carefully insert a thin
object into the battery release, slide the tab over and hold it. Then
slide the battery compartment open.

Battery
Release

Power

Volume

Track Skip (Hold for
Fast-Forward or Rewind)

Power

Volume

Track Skip
(Hold for Fast-Forward
or Rewind)

Play/Pause

Press to Open
the Docking
Cradle

Slide
Connector

• Use only fresh battery of the required size and

recommended type.

• Dispose of old battery promptly and properly.
Do not burn or bury it.

• If you do not plan to use the miDock™10 for a
month or longer, remove the battery. Battery
can leak chemicals that can damage electronic
parts.