Polivac Predator MK III Operation Manual

Polivac Predator MK III

Carpet Extractor Machine

Operations Manual & Trouble Shooting Guide

remove from

skid

connect the

power

connect

solution and

vaccuum

hoses

connect the

wand

fill the

solution tank

turn pump

switches and

vacuum

switches on

on at a time.

now you are

ready to

clean

Connecting the power

Connect the female sockets of the supplied extension cords to the panel
sockets.
Note: You must connect both cord to operate the machine and when
using at pressure above 400 psi, you must connect to two separate
power phases in the building.

Pressure Hose Vacuum Hose

Connect the supplied hoses to the above pictured connection. To
connect the pressure hose push the sleeve back on the brass socket
insert the male plug then release.
To connect the vacuum hose just insert the black hose cuff into plastic
pipe.

Pressure Hose Vacuum hose

Connect the female pressure hose fitting to the male wand connector
and slide the cuff over the end of the wand.
You may need to replace trigger kits See below.

Filling the tank use a bucket or hose to fill the solution tank, you can use
water with a temp up to max of 70 degree Celcius.
If you have the option extra of auto fill, just connect hose to the
Connector on the body.

1. To engage the heater on press the toggle to the heater position.

Please the heater is designed to kept the water heated while not
being used, its intension is not to turn cold water to hot. (switch 1)

2. Before we can start spraying, you need to return the switch the

pump position. (switch 1)

3. Once ready to start turn the round switch on one at a time to

prevent overload on the power.( switch 2,3,4).

4. Opiontal auto pump out, if fitted use switch 5 to turn on.

Pressure gauge / Pressure control

Warning!!! It is important to control the predator pressure output.

Hose Connector

Auto fill Option

5

1

2 3 4