Polivac C25-TS Operations Manual & Trouble Shooting Manual

TWO SPEED POLISHER / SCRUBBER

Operations Manual & Trouble-Shooting Guide

POLIVAC C25-TS

Please find the following correct operating procedure for the operation of the

1. Plug in power cable. Power supply will be visible via the red light on the top of the

handle.

2. Tilt the machine back by using the handle.

3. a) Place the Brush or Pad Holder over the 3 Leaf clover connection and turn it clockwise

to lock the Brush/Pad Holder into position.

b) If the connection has a brass 3 puck clutch fitted, locate the Brush/Pad Holder on the

metal drive clutch, by slotting grooves together, then turn Brush/Pad Holder sharply to

the left.

4. Once the Brush/Pad Holder is fitted, stand the machine back up.

5. Slightly lift the handle up and manoeuvre the wheels backwards and up out of the way

(the wheels must be off the floor when polishing).

6. The handle height must be adjusted to suit individual operators body proportions.

Adjust the ergonomic handle to the correct height by placing your foot or hand on the

ratchet lever, then positioning the handle. The correct height of the handle is around

the groin region.

7. When the handle is set at the correct height, the arms should grip the handle in a

comfortable, but loose manner (if your arms are bent at the elbows this is an indication

that you are applying too much effort to control the machine) Re-adjust the handle.

8. To start the machine, first you must depress the red safety button that is next to the

hand trigger, then grasp either of the red triggers, and the motor will engage the brush.

Do not force the trigger without first releasing the safety button as this will damage the

safety release in the trigger mechanism. Once the machine is on, the safety button can

be released.

9. Always start the machine at high speed, please do not start the machine in slow speed

mode.

How to operate a C2 -5 TS Floor Polisher / Scrubber

Polivac C2 -5 TS Floor Polisher / Scrubber

10. To facilitate the correct swinging motion of the machine, lift the handle slightly forward

to get the polisher to move to the right and lower the handle to get the machine to

move to the left. This requires minimal effort. So, if you are fighting the machine for

control you have the handle set at the wrong height or your pad or cloverleaf locking

mechanism is damaged.

11. Ensure that brushware is removed from the machine after use and before storing

machine away.

Rotary Polisher - C25-TS

Drawings by: LeanSynergicDesign.com.au

Drive & Base Assembly

36

24

25

29

27

26

14

30

34

35

38

39

40

31

22

28

23

41

2

33

16

18

20

21

19

1

10

9

11

12

8

13

11

6

3

7

32

5

4

37

42

17

15

43

44