Polarlite PCA-03-003, PCA-03-005 User guide
Outdoors
•Tree light
•
•
•
•
•3 screws (+ 1 spare screw)
Tree Light
Cherry Blossoms Twigs 180 cm
PCA-03-003
Cherry Blossoms Twigs 120 cm
PCA-03-005
Intended use
Use this product to decorate interior and exterior spaces (IP44).
For safety and approval purposes (CE), you must not rebuild and/
or modify this product. If you use the product for purposes other
than those described above, the product may be damaged. In
addition, improper use can cause hazards such as short circuiting,
fire, electric shock etc. Read the instructions carefully and keep
them. Make this product available to third parties only together
with its operating instructions.
This product complies with the statutory national and European
requirements. All company names and product names are
trademarks of their respective owners. All rights reserved.
Delivery content
Knurled screw
Connection piece
Base
Transformer
•20/10 Replacement blossom
(PCA-03-003/PCA-03-005)
•Operating instructions
Safety instructions
Read the operating instructions carefully and especially
observe the safety information. If you do not follow the
safety instructions and information on proper handling
in this manual, we assume no liability for any resulting
personal injury or damage to property. Such cases will
invalidate the warranty/guarantee.
a) Persons / Product
•The device is not a toy. Keep it out of the reach of children and
pets.
•Do not leave packaging material lying around carelessly. These
may become dangerous playing material for children.
•This decoration must not be connected electrically with other
light chains or decorations.
•Always check the product for damages before use. Should you
discover any damage, cease use of the product. If you discover
damages while the product is in use (i.e. damaged transformer),
do not touch the product, risk of fatal injury due to electric
shock! First remove the power outlet to which the product
is connected from the power supply (flip o the fuse and/or
automatic circuit breaker and then turn o the residual current
operated circuit breaker to disconnect the power outlet at all
phases). Now unplug the transformer from the power outlet.
Discontinue use of the product immediately, dispose of it in an
environmentally friendly fashion.
•Protect the product from extreme temperatures, strong jolts,
flammable gases, vapours and solvents.
•Do not place the product under any mechanical stress.
•If it is no longer possible to operate the product safely, take it
out of operation and protect it from any accidental use. Safe
operation can no longer be guaranteed if the product:
– is visibly damaged,
– is no longer working properly,
– has been stored for extended periods in poor ambient
conditions or
– has been subjected to any serious transport-related stresses.
•Please handle the product carefully. Jolts, impacts or a fall even
from a low height can damage the product.
•The lights become hot during operation. Keep the product away
from highly combustible materials while operating.
•The mains outlet must be located near to the device and be
easily accessible.
•As power supply, only use the supplied transformer.
•Only connect the transformer to a normal mains socket
connected to the public supply. Before plugging in the
transformer, check whether the voltage stated on the
transformer complies with the voltage of your electricity
supplier.
•Never connect or disconnect transformers if your hands are
wet.
•Never unplug the transformer from the mains socket by pulling
on the cable; always use the grips on the plug.
•When setting up the product, make sure that the cable is not
pinched, kinked or damaged by sharp edges.
•Always lay the cables so that nobody can trip over or become
entangled in them. This poses a risk of injury.
•For safety reasons, disconnect the transformer from the mains
socket during storms.
•This product is designed to be used indoors and outdoors.
•Attention, LED light:
– Do not look directly into the LED light!
– Do not look into the beam directly or with optical instruments!
•This product’s flexible power supply cord cannot be exchanged
or repaired. If the cord is damaged, the product must be
disposed of.
Operating instructions
b) Miscellaneous
•Consult an expert when in doubt about operation, safety or
connection of the device.
•Maintenance, modifications and repairs are to be performed
exclusively by an expert or at a qualified shop.
•If you have questions which remain unanswered by these
operating instructions, contact our technical support service or
other technical personnel.
Operation
Do not set up or operate the product under water.
Make sure that the cables hang loosely and are not
stretched too tightly. Failure to heed this warning may
cause the cables to tear.
Do not connect the product to the power supply while
it is still in the packaging. Lay the product out entirely
before connecting it to the power supply.
Do not hang any objects from the product and do not
cover the product.
The LEDs are non-dimmable and non-replaceable.
Observe the following assembly instruction:
A
2
1
5 m
1. Fold back the base (at an angle of 90°).
Insert the connection piece in the base.
Tighten the 3 screws at the base. (1)
2. Insert the crown in the connection piece.
Tighten the knurled screw. (2)
3. Connect the plug connector of the power supply to the
connection socket at the transformer.
4. Secure the connection by turning the screw cap of the plug
connector on the thread at the transformer.
Make sure that the seal at the coupling/plug connector is
provided. If the seal is damaged, the product may not be
used any longer in the outdoor area.
180 m
5. Connect the transformer to the power outlet.
6. The LEDs light up after plugging in.
7. To switch the product o, disconnect the transformer from
the power outlet.
The product has no power switch and is always on as long as
it is connected to the power supply.
The blossoms can be replaced if they are damaged. Carefully
pull o the faulty blossom and insert a new blossom on the
LED. (A)
Maintenance and cleaning
•The product is maintenance-free apart from occasional
cleaning.
•Disconnect the transformer from the power supply before
cleaning and allow the LEDs to cool down suciently.
•To clean, use a clean, dry, lint-free cloth. For stubborn dirt,
slightly dampen the cloth with water.
•Allow the product to dry completely before continued use.
Disposal
Electronic devices are recyclable waste and must not
be disposed of in the household waste. At the end of its
service life, dispose of the product according to the
relevant statutory regulations.
You thus fulfil your statutory obligations and contribute
to the protection of the environment.
Technical data
a) Tree Light
Item No. PCA-03-003 PCA-03-005
Protection type IP44
Operating voltage
Power consumption
Number of lights
4.81 W 0.915 W
380 100
Luminous colour
Power cable length
Operating conditions
Storage conditions
Dimensions (H)
Weight
-20 to +70 °C / 10 – 90 % RH
-20 to +70 °C / 10 – 90 % RH
180 cm 120 cm
approx. 2.7 kg approx. 1.2 kg
b) Transformer
Protection type
Input voltage
100 - 240 V/AC, 50/60 Hz
Output voltage
Output current
193 mA 116 mA
Output power
These operating instructions are published by CEI Conrad Electronic International (HK) Limited, 18th Floor, Tower 2,
Nina Tower, No. 8 Yeung Uk Road, Tsuen Wan, New Territories, Hong Kong. All rights including translation reserved.
Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data processing systems
require the prior written approval by the editor. Reprinting, also in part, is prohibited. The operating instructions
reflect the current technical specifications at time of print.
© Copyright 2015 by CEI Conrad Electronic International (HK) Limited
distributed by Conrad Electronic SE,
Klaus-Conrad-Str. 1, D-92240 Hirschau
31 V/DC
Cool White
5 m
IP44
31 V/DC
max. 6 W
PCA-03-003-005_v2_0715_02_m_EN(1)
Loading...