Polarlite LBA-30-007 User guide
Indoors
Battery Operated
Decoration
LED Wax Candles with
Remote Control, Set of 3
LBA-30-007
Operating instructions
Intended use
The battery operated LED Wax Candles are intended for indoor
decoration and are controlled by the remote control including a
button cell battery provided. Each LED Wax Candle is operated
with three AAA batteries (included).
For safety and approval purposes (CE), you must not rebuild and/
or modify this product. If you use the product for purposes other
than those described above, the product may be damaged. In
addition, improper use can cause hazards such as short circuiting,
fire, electric shock etc. Read the instructions carefully and keep
them. Make this product available to third parties only together
with its operating instructions.
This product complies with the statutory national and European
requirements. All company names and product names are
trademarks of their respective owners. All rights reserved.
Delivery content
•Battery operated decoration
•9 AAA batteries
•Remote control
•Button cell battery (CR2025)
•Operating instructions
Safety instructions
Read the operating instructions carefully and especially
observe the safety information. If you do not follow the
safety instructions and information on proper handling
in this manual, we assume no liability for any resulting
personal injury or damage to property. Such cases will
invalidate the warranty/guarantee.
a) Persons / Product
•The device is not a toy. Keep it out of the reach of children and
pets.
•Do not leave packaging material lying around carelessly. These
may become dangerous playing material for children.
•Always check the product for damages before use. Should you
discover any damage, cease use of the product.
•Protect the product from extreme temperatures, direct sunlight,
strong jolts, high humidity, moisture, flammable gases, vapours
and solvents.
•Do not place the product under any mechanical stress.
•If it is no longer possible to operate the product safely, take it
out of operation and protect it from any accidental use. Safe
operation can no longer be guaranteed if the product:
– is visibly damaged,
– is no longer working properly,
– has been stored for extended periods in poor ambient
conditions or
– has been subjected to any serious transport-related stresses.
•Please handle the product carefully. Jolts, impacts or a fall even
from a low height can damage the product.
•The LED heats up during use. Keep the product away from
highly combustible materials while operating.
•This product is designed to be used indoors only.
•Attention, LED light:
– Do not look directly into the LED light!
– Do not look into the beam directly or with optical instruments!
b) Batteries
•Correct polarity must be observed while inserting the batteries.
•Remove the batteries if you are not using the product for a
long period of time to prevent damage due to leaks. Leaking
or damaged batteries might cause acid burns when in contact
with skin, therefore use suitable protective gloves to handle
corrupted batteries.
•Batteries must be kept out of reach of children. Do not leave
batteries lying around, as there is risk, that children or pets
swallow them.
•All batteries should be replaced at the same time. Mixing old
and new batteries can cause the batteries to leak and the
product to be damaged.
•Batteries must not be dismantled, short-circuited or thrown into
fire. Never recharge non-rechargeable batteries. There is a risk
of explosion!
c) Miscellaneous
•Maintenance, modifications and repairs are to be performed
exclusively by an expert or at a qualified shop.
•If you have questions which remain unanswered by these
operating instructions, contact our technical support service or
other technical personnel.
Product overview
150 mm
1
10
6
ON OFF
2
TIMER
4H 8H
MODE
Candle Light
3
4
5
75 mm
100 mm
button
(backside)
75 mm
8 Candle button
9 4 H button
10 ON button
9
8
7
1 Infrared LED 4 Light button 7 button
2 OFF button 5
3 8 H button 6 Battery compartment
Operation
The product must not be used in or under water.
Do not operate the product if it is still in its packaging.
Do not hang any objects from the product and do not
cover the product.
Do not place the product near sources of heat such as
chimneys or stoves.
The LED is non-replaceable.
Remove the insulating strips from the battery compartments
of the LED Wax Candles before first-time use.
1. Remove the product from the packaging.
2. Place the product on a dry, horizontal surface, e.g. a table,
window ledge, etc.
125 mm
75 mm
3. Turn the product on or o using the switch on the bottom
(ON = On, OFF = O).
4. Turn o the product and remove the batteries for extended
periods of disuse.
Replace the batteries when the LED no longer lights up.
Remote control
Remove the insulation strip from the battery compartment
(6) of the remote control before first time use.
•Make sure there are no obstacles located between the infrared
LED (1) of the remote control and the LED Wax Candles.
•If you do not want to operate all the LED Wax Candles, move a
bit closer towards the LED Wax Candle, thereby ensuring visual
contact between remote control and LED Wax Candle.
•The operating range of the remote control depends on the
ambient conditions and the battery capacity.
•Replacing the battery is required when the operating range
of the remote control drops significantly or if the LED Wax
Candles cannot be operated when pressing any button.
•Open the battery compartment as indicated on the backside of
the remote control and remove the old battery.
•Insert a button cell battery of type CR2025 into the battery
holder, making sure the positive terminal (“+” marking on the
battery) faces up.
•Push the battery holder back into the battery compartment to
close. Make sure the battery holder locks into place.
Description of buttons
ON button (10) Turn on the LED Wax Candles
OFF button (2) Turn o the LED Wax Candles
button (5) / button (7) Dimmer function
Light
button
(4)
Steady lighting function
Candle button (8) Flickering mode
4 H button (9) /
8 H button (3)
Timer function: The LED Wax
Candles will automatically turn
o after 4 or 8 hours. In order to
turn them on again, press the ON
button (10) on the remote control.
Maintenance and cleaning
•The product is maintenance-free, except for any change of
batteries and occasional cleaning.
•Turn o the product and let it cool down suciently before
cleaning.
•To clean, use a clean, dry, lint-free cloth. For stubborn dirt,
slightly dampen the cloth with water. Allow the product to dry
completely before continued use.
Disposal
a) Product
Electronic devices are recyclable waste and must not
be disposed of in the household waste. At the end of its
service life, dispose of the product according to the
relevant statutory regulations.
Remove any inserted batteries and dispose of them
separately from the product.
b) Batteries
You as the end user are required by law (Battery
Ordinance) to return all used batteries. Disposing of
them in the household waste is prohibited.
Contaminated batteries are labelled with this symbol to indicate
that disposal in the domestic waste is forbidden. The designations
for the heavy metals involved are: Cd = Cadmium, Hg = Mercury,
Pb = Lead (name on batteries, e.g. below the trash icon on the
left).
Used batteries can be returned to collection points in your
municipality, our stores or wherever batteries are sold.
You thus fulfil your statutory obligations and contribute to the
protection of the environment.
Technical data
a) LED Wax Candle
Operating voltage .................................4.5 V (3 x 1.5 V batteries,
type AAA)
Power consumption .............................0.06 W
Battery life ................................................approx. 200 h
Number of lights ....................................1
Luminous colour ....................................Warm White
Operating conditions ..........................-10 to +40 °C / 10 – 90 % RH
Storage conditions ...............................-10 to +40 °C / 10 – 90 % RH
Dimensions (H x W) .............................100/125/150 x 75 mm
Weight (Set of 3) ..................................670 g (incl. batteries)
b) Remote control
Operating voltage .................................3 V lithium battery,
.type CR2025
These operating instructions are published by CEI Conrad Electronic International (HK) Limited, 18th Floor, Tower 2,
Nina Tower, No. 8 Yeung Uk Road, Tsuen Wan, New Territories, Hong Kong. All rights including translation reserved.
Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data processing systems
require the prior written approval by the editor. Reprinting, also in part, is prohibited. The operating instructions
reflect the current technical specifications at time of print.
© Copyright 2015 by CEI Conrad Electronic International (HK) Limited
distributed by Conrad Electronic SE,
Klaus-Conrad-Str. 1, D-92240 Hirschau
LBA-30-007_v1_0515_02_m_EN
Loading...