Polarlite 1676604 User guide
Indoors
Battery Operated
Decoration
LED real wax candle,
set of 3
Item no. 1676604
Intended use
The battery-operated LED candles are intended for decorative
purposes in indoor areas. Each is operated by two AA batteries
(not included in the delivery scope). The product generates a
flickering eect.
For safety and approval purposes, you must not rebuild and/or
modify this product. If you use the product for purposes other
than those described above, the product may be damaged. In
addition, improper use can cause hazards such as short circuiting,
fire etc. Read the instructions carefully and keep them. Make this
product available to third parties only together with its operating
instructions.
This product complies with the statutory national and European
requirements. All company names and product names are
trademarks of their respective owners. All rights reserved.
Delivery content
• Battery operated decoration
• Operating instructions
Safety instructions
Read the operating instructions carefully and especially
observe the safety information. If you do not follow the
safety instructions and information on proper handling
in this manual, we assume no liability for any resulting
personal injury or damage to property. Such cases will
invalidate the warranty/guarantee.
a) Persons / Product
• The device is not a toy. Keep it out of the reach of children and
pets.
• Do not leave packaging material lying around carelessly. These
may become dangerous playing material for children.
• Always check the product for damages before use. Should you
discover any damage, cease use of the product.
• Protect the product from extreme temperatures, direct sunlight,
strong jolts, high humidity, moisture, flammable gases, vapours
and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it
out of operation and protect it from any accidental use. Safe
operation can no longer be guaranteed if the product:
– is visibly damaged,
– is no longer working properly,
– has been stored for extended periods in poor ambient
conditions or
– has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even
from a low height can damage the product.
• The LED heats up during use. Keep the product away from
highly combustible materials while operating.
• This product is designed to be used indoors only.
• Attention, LED light:
– Do not look directly into the LED light!
– Do not look into the beam directly or with optical instruments!
• The product consists of real wax and is flammable. Protect it
from direct sunlight, naked flames and other heat sources. Do
not light the wick.
b) Batteries
• Correct polarity must be observed while inserting the batteries.
• Remove the batteries if you are not using the product for a
long period of time to prevent damage due to leaks. Leaking
or damaged batteries might cause acid burns when in contact
with skin, therefore use suitable protective gloves to handle
corrupted batteries.
• Batteries must be kept out of reach of children. Do not leave
batteries lying around, as there is risk, that children or pets
swallow them.
• All batteries should be replaced at the same time. Mixing old
and new batteries can cause the batteries to leak and the
product to be damaged.
• Batteries must not be dismantled, short-circuited or thrown into
fire. Never recharge non-rechargeable batteries. There is a risk
of explosion!
c) Miscellaneous
• Maintenance, modifications and repairs are to be performed
exclusively by an expert or at a qualified shop.
• If you have questions which remain unanswered by these
operating instructions, contact our technical support service or
other technical personnel.
Operating instructions
Product overview
Operation
The product must not be used in or under water.
Do not operate the product if it is still in its packaging.
Do not hang any objects from the product and do not
cover the product.
Do not place the product near sources of heat such as
chimneys or stoves.
The LED is non-dimmable and non-replaceable.
1. Remove the product from the packaging. Remove the
protective foil.
2. Place the product on a horizontal surface such as a garden
table.
3. Remove the battery compartment cover.
4. Insert two AA batteries. We recommend using high-quality
batteries. Ensure that the batteries are inserted in the correct
polarity ( “+” = positive; “-” = negative), as indicated in the
battery compartment.
5. Replace the battery compartment cover.
6. To turn the light on and o, move the switch on the bottom
of the product to the On or O position.
7. If you do not plan to use the product for an extended period,
turn it o and remove the batteries.
Inserting/replacing the batteries
Replace the batteries if the LED stops working. Ensure that
no liquids get into the interior of the battery compartment
when changing the batteries.
• Ensure that the on/o switch is set to the O position before
opening the battery compartment.
• Remove the battery compartment cover.
• Remove the used batteries.
• Insert two new AA-batteries. We recommend using high-quality
batteries. Ensure that the batteries are inserted in the correct
polarity ( “+” = positive; “-” = negative), as indicated in the
battery compartment.
• Close the battery compartment. The battery compartment
cover must audibly click into place.
Care and cleaning
• Turn o the product and let it cool down suciently before
cleaning.
• Remove the batteries before cleaning.
• Do not use abrasive detergents, rubbing alcohol or other
chemical solutions, as these may damage the casing or stop the
product from functioning properly.
• Use a clean, dry, lint-free cloth to clean the product. Do not
pinch the real wax too hard, as this can lead to scratch marks or
damage.
Disposal
a) Product
Electronic devices are recyclable waste and must not
be disposed of in the household waste. At the end of its
service life, dispose of the product according to the
relevant statutory regulations.
Remove any inserted batteries and dispose of them
separately from the product.
b) Batteries
You as the end user are required by law (Battery
Ordinance) to return all used batteries. Disposing of
them in the household waste is prohibited.
Contaminated batteries are labelled with this symbol to indicate
that disposal in the domestic waste is forbidden. The designations
for the heavy metals involved are: Cd = Cadmium, Hg = Mercury,
Pb = Lead (name on batteries, e.g. below the trash icon on the
left).
Used batteries can be returned to collection points in your
municipality, our stores or wherever batteries are sold.
You thus fulfil your statutory obligations and contribute to the
protection of the environment.
Technical data
Operating voltage 3 V (2 x 1.5 V batteries, type AA)
Power consumption 0.06 W
Light ON time (continuous
operation)
Number of LEDs 1
Luminous colour Warm White
LED life 30,000 hours
Operating conditions -5 to +40 °C
Storage conditions -5 to +40 °C
Dimensions (H x Ø) 195 x 50 mm
Weight 168 g
These operating instructions are published by CEI Conrad Electronic International (HK) Limited, 18th Floor, Tower 2,
Nina Tower, No. 8 Yeung Uk Road, Tsuen Wan, New Territories, Hong Kong. All rights including translation reserved.
Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data processing systems
require the prior written approval by the editor. Reprinting, also in part, is prohibited. These operating instructions
represent the technical status at the time of printing.
© Copyright 2018 by CEI Conrad Electronic International (HK) Limited
approx. 200 hours
170 x 50 mm
145 x 50 mm
157 g
126 g
distributed by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
1676604_v1_0718_02_jh_m_en
Loading...