Polarlite 1674565, 1674564 User guide
Indoors
Battery Operated
Decoration
Iron LED lantern 450
Item no. 1674565
Iron LED lantern 350
Item no. 1674564
Operating Instructions
Intended use
This product is battery-operated and is designed to decorate
indoor areas. It is powered by two AA batteries (not included).
The product features a timer function and generates a flickering
eect.
For safety and approval purposes, you must not rebuild and/or
modify this product. Using the product for purposes other than
those described above may damage the product. In addition,
improper use can cause hazards such as a short circuit or fire.
Read the instructions carefully and store them in a safe place.
Make this product available to third parties only together with its
operating instructions.
This product complies with statutory national and European
regulations. All company and product names are trademarks of
their respective owners. All rights reserved.
Delivery content
• Iron LED lantern 450 or 350
• Operating Instructions
Safety instructions
Read the operating instructions and safety information
carefully. If you do not follow the safety instructions
and information on proper handling in this manual, we
assume no liability for any resulting personal injury
or damage to property. Such cases will invalidate the
warranty/guarantee.
a) Persons / Product
• This product is not a toy. Keep it out of the reach of children
and pets.
• Do not leave packaging material lying around carelessly, as it
may become dangerous playing material for children.
• Check the product for damage before each use. If there are any
signs of damage, discontinue use immediately.
• Protect the product from extreme temperatures, direct sunlight,
strong jolts, high humidity, moisture, flammable gases, vapours
and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, stop
using it and prevent unauthorized use. Safe operation can no
longer be guaranteed if the product:
– is visibly damaged,
– is no longer working properly,
– has been stored for extended periods in poor ambient
conditions or
– has been subjected to any serious transport-related stress.
• Always handle the product carefully. Jolts, impacts or a fall even
from a low height may damage the product.
• The LED becomes warm during use. Keep the product away
from flammable materials.
• This product is intended for indoor use only.
• Place the product in a location where nobody can trip over it, as
this may cause an injury.
• Warning, LED light:
– Do not look directly at the LED light!
– Do not look into the beam directly or with optical instruments!
• Do not light the wick.
b) Battery
• Ensure that the battery is inserted in the correct polarity.
• To prevent battery leakage, remove the battery when you do
not plan to use the product for an extended period. Leaking or
damaged batteries may cause acid burns when they come into
contact with skin. Always use protective gloves when handling
damaged batteries.
• Keep batteries out of the reach of children. Do not leave
batteries lying around, as they constitute a choking hazard for
children and pets.
• Replace all batteries at the same time. Mixing old and new
batteries may cause the batteries to leak and damage the
lantern.
• Batteries must not be dismantled, short-circuited or thrown into
fire. Never recharge non-rechargeable batteries, as this may
cause an explosion.
c) Miscellaneous
• Maintenance, modifications and repairs must be done by a
technician or an authorized repair center.
• If you have questions which remain unanswered by these
operating instructions, contact our technical support service or
other technical personnel.
Product overview
45.8 cm
9 cm
9.1 cm
24.1 cm
Item No. 1674565 Item No. 1674564
19.1 cm
35.5 cm
Operation
The product must not be used in or under water.
Do not use the product when it is still in the packaging.
Do not hang objects on the product or cover the
product.
Do not place the product near to sources of heat such
as fireplaces or stoves.
The LED is not dimmable and cannot be replaced.
1. Remove the product from the packaging.
2. Place the product on a dry horizontal surface such as a table
or windowsill.
3. Remove the battery compartment cover.
4. Insert two AA batteries. We recommend using high-quality
batteries. Ensure that the batteries are inserted in the correct
polarity (“+” = positive; “-“ = negative).
5. Replace the battery compartment cover.
6. To turn the light on and o, move the switch on the bottom
of the product to the ON or OFF position.
7. The product comes with a timer function. The light turns
on for approximately 5 hours, and then turns back on
automatically after 19 hours.
Example: You switch on the light at 3:00 pm and move the
switch to the Timer 5H ON + 19H OFF position. The light
will turn on from 3:00 pm to 8:00 pm and then switch o
automatically. It will turn back on again at 3:00 pm on the
following day. This cycle is repeated provided that the on/
o switch is set to the TIMER position and there is sucient
battery power remaining.
8. If you do not plan to use the product for an extended period,
turn it o and remove the batteries.
Replacing the batteries
Replace the batteries if the LED stops working.
• Ensure that the on/o switch is set to the OFF position before
opening the battery compartment.
• Remove the battery compartment cover.
• Remove the used batteries.
• Insert two new AA-batteries. We recommend using high-quality
batteries. Ensure that the batteries are inserted in the correct
polarity (“+” = positive; “-” = negative).
• Close the battery compartment and ensure that it snaps into
place.
Care and cleaning
• Before cleaning the product, turn o the light and let it cool
down suciently.
• Remove the batteries before cleaning the product.
• Do not use abrasive detergents, rubbing alcohol or other
chemical solutions, as these may damage the casing or stop the
product from functioning properly.
• Use a clean, dry, lint-free cloth to clean the product. To remove
stubborn dirt, moisten the cloth slightly with water.
• Allow the product to dry out completely before using it again.
Disposal
a) Product
Electronic devices are recyclable waste and must not
be placed in household waste. Always dispose of the
product according to the relevant statutory regulations.
Remove any inserted batteries and dispose of them
separately from the product.
b) Batteries
You are required by law to return all used batteries. They
must not be placed in household waste.
Batteries that contain hazardous substances are labelled with
this symbol to indicate that disposal in household waste is
forbidden. The abbreviations for heavy metals in batteries are: Cd
= Cadmium, Hg = Mercury, Pb = Lead (indicated on the battery,
e.g. below the waste icon on the left).
Used batteries can be returned to local collection points, our
stores or battery retailers.
You thus fulfil your statutory obligations and contribute to the
protection of the environment.
Technical data
Item No. 1674565 1674564
Protection rating IP20
Power supply 2 x 1.5 V batteries, type AA
Power consumption 0.06 W
Battery life approx. 400 hours / 2 months with timer
Number of lights 1
Lamp colour Amber flicker light
Operating conditions 0 to +40 °C, 0 – 90 % RH
Storage conditions 0 to +40 °C, 0 – 90 % RH
Dimensions (Ø x H) 24.1 x 9.1 x 45.8 cm 19.1 x 9 x 35.5 cm
Weight 1100 g 880 g
These operating instructions are published by CEI Conrad Electronic International (HK) Limited, 18th Floor, Tower 2,
Nina Tower, No. 8 Yeung Uk Road, Tsuen Wan, New Territories, Hong Kong. All rights including translation reserved.
Reproduction by any method (e.g. photocopying, microfilming, or the capture in electronic data processing
systems) requires prior written approval from the editor. Reprinting, also in part, is prohibited. These operating
instructions reflect the current technical specifications at the time of printing.
© Copyright 2018 by CEI Conrad Electronic International (HK) Limited
Distributed by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
1674565_1674564_V3_1018_02_mxs_m_en
Loading...