Outdoors
Battery Operated
Decoration
Real wax LED candle
Item no. 1642711 Shining Silver
Real wax LED candle
Item no. 1642712 Chocolate
Real wax LED candle
Item no. 1642713 Warm Red
Operating instructions
Intended use
The product is battery-operated and serves for decoration
indoors and outdoors (IPx4). It is powered by two AA batteries
(not included). The product features a timer function and
generates a flickering eect.
For safety and approval purposes, you must not rebuild and/or
modify this product. Using the product for purposes other than
those described above may damage the product. In addition,
improper use may cause hazards such as a fire or short circuit.
Read the instructions carefully and store them in a safe place.
Only make this product available to third parties together with its
operating instructions.
This product complies with statutory national and European
regulations. All company and product names are trademarks of
their respective owners. All rights reserved.
Delivery contents
• Battery operated decoration
• Operating instructions
Safety instructions
Read the operating instructions and safety information
carefully. If you do not follow the safety instructions
and information on proper handling in this manual, we
will assume no liability for any resulting personal injury
or damage to property. Such cases will invalidate the
warranty/guarantee.
a) Persons / Product
• The device is not a toy. Keep it out of the reach of children and
pets.
• Do not leave packaging material lying around carelessly. It may
become a dangerous toy for children.
• Check the product for damage before each use. If there are any
signs of damage, discontinue use immediately.
• Protect the product from extreme temperatures, direct sunlight,
strong jolts, flammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, stop
using it and prevent unauthorized use. Safe operation can no
longer be guaranteed if the product:
– is visibly damaged,
– is no longer working properly,
– has been stored for extended periods in poor ambient
conditions or
– has been subjected to any serious transport-related stress.
• Always handle the product carefully. Jolts, impacts or a fall even
from a low height may damage the product.
• The LED becomes warm during use. Keep the product away
from flammable materials.
• This product is designed for indoor and outdoor use.
• Warning, LED light:
– Do not look directly at the LED light!
– Do not look into the beam directly or with optical instruments!
• The product consists of real wax and is flammable. Protect it
from direct sunlight, naked flames and other heat sources. Do
not light the wick.
b) Batteries
• Check that the batteries are inserted with the correct polarity.
• To prevent battery leakage, remove the batteries when you do
not plan to use the product for an extended period. Leaking or
damaged batteries may cause acid burns when they come into
contact with skin. Always use protective gloves when handling
damaged batteries.
• Keep batteries out of the reach of children. Do not leave
batteries lying around, as they constitute a choking hazard for
children and pets.
• Replace all of the batteries at the same time. Mixing old and
new batteries may cause the batteries to leak and damage the
lantern.
• Batteries must not be dismantled, short-circuited or thrown
into fire. Never recharge non-rechargeable batteries. Danger of
explosion!
c) Miscellaneous
• Maintenance, modifications and repairs must be done by a
technician or a specialist repair centre.
• If you have questions which remain unanswered by these
operating instructions, contact our technical support service or
other technical personnel.
Product Overview
Operation
The product must not be used in or under water.
Do not use the product when it is still in the packaging.
Do not hang objects on the product or cover the
product.
Do not place the product near sources of heat such as
fireplaces or stoves.
The LED is not dimmable and cannot be replaced.
1. Remove the product from the packaging. Remove the
protective foil.
2. Place the product on a horizontal surface such as a garden
table.
3. Remove the battery compartment cover.
4. Insert two AA batteries. We recommend using high-quality
batteries. Ensure that the batteries are inserted in the correct
polarity ( "+" = positive; "-" = negative), as indicated in the
battery compartment.
5. Replace the battery compartment cover.
6. To turn the light on and o, move the switch on the bottom
of the product to the On or O position.
7. The product comes with a timer function. After burning for
approx. 5 hours, the product turns o automatically and then
turns back on 19 hours later.
Example: Slide the on/o switch to Timer at 3:00 pm. The
light will turn on from 3:00 pm to 8:00 pm and then switch
o automatically. It will turn back on again at 3:00 pm on the
following day. This cycle is repeated provided that the on/
o switch is set to the Timer position and there is sucient
battery power remaining.
8. If you do not plan to use the product for an extended period,
turn it o and remove the batteries.
Inserting the batteries
Replace the batteries if the LED stops working.
Ensure that no liquids get into the interior of the battery
compartment when changing the batteries.
• Ensure that the on/o switch is set to the O position before
opening the battery compartment.
• Remove the battery compartment cover.
• Remove the used batteries.
• Insert two new AA-batteries. We recommend using high-quality
batteries. Ensure that the batteries are inserted in the correct
polarity ( "+" = positive; "-" = negative), as indicated in the
battery compartment.
• Close the battery compartment. The battery compartment
cover must audibly click into place.
Care and cleaning
• Turn o the product and let it cool down suciently before
cleaning.
• Remove the batteries before cleaning the product.
• Do not use abrasive detergents, rubbing alcohol or other
chemical solutions, as these may damage the casing or stop the
product from functioning properly.
• Use a clean, dry, lint-free cloth to clean the product. Do not
pinch the real wax too hard, as this can lead to scratch marks or
damage.
Disposal
a) Product
Electronic devices are recyclable waste and must not
be placed in household waste. At the end of its service
life, dispose of the product according to the relevant
statutory regulations.
Remove any inserted batteries and dispose of them
separately from the product.
b) Batteries
You are required by law to return all used batteries.
They must not be placed in household waste.
Batteries that contain hazardous substances are
labelled with this symbol to indicate that disposal in
domestic waste is forbidden. The abbreviations for
heavy metals in batteries are: Cd = Cadmium, Hg =
Mercury, Pb = Lead (indicated on the battery, e.g.
below the waste icon on the left).
Used batteries can be returned to local collection points, our
stores or battery retailers.
You thus fulfil your statutory obligations and contribute to the
protection of the environment.
Technical data
Operating voltage 3 V (2 x 1.5 V batteries, type AA)
Power consumption 0.06 W
Light ON time (continuous
operation)
Light ON time (timer) approx. 30 days
Number of LEDs 1
Lamp colour Warm white
LED life 30,000 hours
Operating conditions -5 to +40 °C
Storage conditions -5 to +40 °C
Dimensions (H x Ø) 130 x 82 mm
Weight 255 g
approx. 200 hours
These operating instructions are published by CEI Conrad Electronic International (HK) Limited, 18th Floor, Tower 2,
Nina Tower, No. 8 Yeung Uk Road, Tsuen Wan, New Territories, Hong Kong. All rights including translation reserved.
Reproduction by any method (e.g. photocopying, microfilming, or the capture in electronic data processing
systems) requires prior written approval from the editor. Reprinting, also in part, is prohibited. The operating
instructions reflect the current technical specifications at time of print.
© Copyright 2018 by CEI Conrad Electronic International (HK) Limited
Distributed by
Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
1642711_12_13_V2_0218_02_hk_m_EN.indd
Loading...