Polaris PR199-100-3NV User Manual

brought to Canada by
brought to Canada by
Requires 120 Volt 60Hz Power Supply. Draws less than 5 Amps
NOTE: SEE INSTALLATION MANUAL FOR PIPING DIAGRAMS.
N T
3 1/ 2" D IA . -T
CONCENTRIC VENT KIT
(OPTIONAL)
TANK
MODEL NUMBER
PR100-34-2NV 34
PR130-34-2NV 34 130,000 96 166 48.5 22 15.75 40.5 41 6-1/8 150
CAP.
(GAL.)
INPUT
BTU PER
HOUR
100,000 96 129 48.5
THERMAL
EFFICIENCY
G.P.H.
REC.
90'
RISE
EXTERIOR
A B
22
1 " WATER
CONNECTIONS
C D
15.75 40.5
Note: Dimension *G’ = 5 3/4"
T&P
HGT.
E
41
1/2" GAS
SUPPLY
F
6-1/8 150
APPROX.
SHIP
WT.
HIGH-EFFICIENCY RESIDENTIAL GAS WATER HEATER
10-Year Tank Warranty 1 -Year Parts Warranty
•Stainless Steel Tank with Submerged Combustion
High grade 444 stainless steel tank with brass connections for years of dependable, trouble-free service - no anode required. Submerged combustion chamber with spiral flue for 95-96% thermal efficiency and ultra-low standby heat loss of approximately 1%.
•Sealed Combustion with Woven Fibre Premix Burner
Metal fibre burner is designed for clean combustion in high-intensity blue flame mode. Manufactured of refractory steel that resists corrosion. Excellent resistance to thermal and mechanical shock, even at extreme temperatures. Uniform combustion
provides excellent heat transfer. Meets Low NOx requirements for California and Texas.
•Whisper Quiet Operation
Ultra quiet blower and burner minimize noise.
•Power/Direct Vent Using 2" or 3" Plastic Pipe
Direct vents up to 120' using PVC, CPVC, or ABS pipe. Vents through-the-wall or roof. Optional concentric vent kit available for use through-the-roof or wall.
•Plug-and-Play Technology
No special adjustments are required at initial start up. Connect air inlet, exhaust outlet, water, electricity, and gas, set the temperature and the system functions
properly.
PR130-S0-2NV 50 130,000 95 166 62.5 22 15.75 54.5 55 6-1/8 176
PR150-34-2NV 34
PR199-100-3NV 100 199,000 96 257 70 28 23.25 56.25 63 6-3/8 486
For propane, substitute “P” for “N" in the modei number. 3" Concentric Vent Part #6910543 or 2" Concentric Vent Part #6910542. Specifications are subject to change without notice in accordance with our poiicy of continuous improvement, input, output and recovery may vary depending upon air iniet and exhaust outlet instaliations. Length and number of bends in inlet and outiet pipes may reduce input and output. Consult instaiiation, operation and service manual for details. Dimensions on all charts shown in inches.
Specification
Residential gas-fired water heater(s) shall be a direct/power vent Polaris model
_______
as manufactured by American Water Heater Company and shall have a 10­year limited tank warranty and a 1-year limited parts warranty, as outlined in the written warranty. Units shall be designed to burn
International certified to the latest edition of ANSI standard Z21.10.3/CSA 4.3. Water heater(s) shall have a nominal storage capacity of ____
GPH @ 90PF rise with a rated input of
condensing type with a minimum thermal efficiency of 95-96%, power vented with PVC, ABS, or CPVC pipe. Water heater(s) shall have combined vent capabilities of up to 120' to the exhaust outlet with up to 120' to the air inlet. Water heater(s) shall have a low noise combustion system with a woven fibre steel burner capable of low NOx (less than 40 ng/j) in the blue flame mode and shall be manufactured of refractory steel, resistant to thermal and mechanical shock. The gas valve shall be a Honeywell CV1-r1 series gas valve with a matching 45.900 series venturi manifold using a 1:1 air/gas ratio. The combustion system shall be factory adjusted and require no field adjustment on startup. The tank shall be constructed of 444 stainless steel with a submerged combustion chamber and rated for 150 PSI working pressure and 300 PSI test pressure. The tank shall be surrounded by two inches of non-CFC foam insulation covered by an enamel coated metal jacket. Operating controls shall have a 24-volt integrated control circuit, an immersed thermistor temperature sensor, a recycling energy cut-off switch, external temperature adjustment, and shall have LED lights that continuously indicate the operational status of the water heater(s). A microprocessor shall automatically monitor nine critical operating functions and signal the status of each. A factory installed temperature and pressure relief valve shall be provided on all models. A factory provided water thermostatic tempering valve shall be provided with all models.
150,000 95 186 48.5
_________
(natural/propane) gas and be CSA
______
________
gallons and a recovery rate of
BTU/Hr. Water heater(s) shall be
22
15.75 40.5
41
Order Entry and Sales
GSIV Water Heating
A GSIV Inc. Company
599 Hill Street West,
Fergus, ON, Canada N1M 2X1
Tel: 1-888-599-2837
Product Service and Support
P.O. Box 1597, 500 Princeton Road Johnson City, TN 37605-1597
Tel: 1-800-456-9805
Fax: 1-800-999-5210
Distributed By
6-1/8 150
•Self-Diagnostic Control System
Three external LED lights indicate operational status of water heater. Microprocessor monitors nine critical functions. An LED troubleshooting light, visible through view
port, signals heater operation status.
•Full Serviceability from the Front
Removal of two front-located access panels exposes all serviceable components. Modular components are easily removed.
•Multiple 1" Tank Connections - Brass
Potable water and space heating connections provided. Use with potable water only.
•Factory Provided Tempering Valve
Helps stretch hot water supply by automatically mixing hot and cold water.
•Other Features
Thermister Temperature Sensor
Hot Surface Ignition
ASHRAE 90.1 b-1992 Compliant
Factory Installed T&P Valve
Complies with California Title 24
24-Volt Thermostat Control Full Flow Brass Drain Valve Zero Clearance to Combustibles Factory Provided Condensate Trap (CPVC)
•CSA International Certified to ANSI Z21.10.3/CSA 4.3
Copyright© by American Water Heater Company
2002. Aii rights reserved.
All rights reserved. No port of this work may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying and recording, or by any information storage retrieval system, without permission in writing from American Water Heater Company.
12/05 RP133C
All rights reserved. No port of this work may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying and recording, or by any inhumation storage retrieval system, without permission in writing from American Water Heater Company.
12/05 RP133C
95+% Efficient
1. The quiet, brushless DC blower prepurges the submerged combustion chamber for 8 seconds and turns off.
2. The hot surface igniter is energized and glows red hot.
3. The blower turns on, precisely mixing air and gas for combustion. The mixture is forced through the metal fibre burner and is ignited by the hot surface igniter. A blue flame is evenly distributed across the entire burner, resulting in clean combustion with low nitrous oxide emissions.
4. The combustion chamber wall transfers high temperature heat from the flame to the water.
5. The blower pushes hot combustion gases through the spiral coil, which scrubs the remaining heat from the hot gases.
6. As combustion gas exits the bottom of the spiral coil, it is barely warm to the touch. Over 95% of the heat from the flame is transferred to the water.
7. Combustion gases are vented through PVC, CPC or ABS plastic pipe.
8
. Condensation formed by cooled combustion air is captured by a
condensate trap and drained through a drain line.
The Best Choice for
Hot Water
Polaris is ideal for large homes. For dishwashing,
showers, baths, clothes washing, or hot tubs, Polaris is the best choice. Polaris models heat up to 257 GPH at a 90PF temperature rise, compared to 41 GPH for standard gas water heaters.
Polaris Combines Water Heating with Space Heating
Forced Air
Hydronic Heat
Polaris can be used to combine an air handler for comfortable forced air hydronic space heating with potable hot water. Hot water is circulated through a coil in the air handler. Air from the home is warmed as it is blown across the coil. Warmed air is returned to the home through air ducts. With up to 199,000
BTUs, Polaris can heat most homes, large or small.
The Quiet Way to
Efficiently
Heat Water
An ultra quiet radial blower is combined with a submerged burner for whisper quiet operation. Indicator lights illuminate when the power is on and when the igniter and burner are operating.
Radiant Hydronic
Heat
Polaris works great for homeowners who prefer radiant hydronic heat. With radiant floor hydronic systems, potable hot water is circulated through tubes under the floor. The floor absorbs heat from the tubes and radiates it into the room. With radiant baseboard heat, potable hot water is circulated through finned tube baseboard. Heat rises from the baseboard heaters, warming the home. All water components must be approved for use with potable water.
Illustration provided by Uponor Wirsbo
Loading...